TLV320AIC1103PBSR Datasheet, PDF (1/33 Pages) Texas Instruments – PCM CODEC

TLV320AIC1103
PCM CODEC
SLAS356 − DECEMBER 2001
FEATURES
D 2.7-V Operation
D Two Differential Microphone Inputs, One
Differential Earphone Output, and One
Single-Ended Earphone Output
D Programmable Gain Amplifiers for Transmit,
Receive, Sidetone, and Volume Control
D Earphone Mute and Microphone Mute
D On-Chip I²C Bus, Which Provides a Simple,
Standard, Two-Wire Serial Interface With
Digital ICs
D Programmable for 15-Bit Linear Data or 8-Bit
Companded (µ-Law or A-Law) Data
D Available in a 32-Pin Thin Quad Flatpack
(TQFP) Package and an 80-Pin GQE MicroStar
Juniort Ball Grid Array (BGA)
D Designed for Analog and Digital Wireless
Handsets and Telecommunications
Applications
D Dual-Tone Multifrequency (DTMF) and Single
Tone Generator
D Pulse Density Modulated (PDM) Buzzer
Output
APPLICATIONS
D Digital Handset
D Digital Headset
D Cordless Phones
D Digital PABX
D Digital Voice Recording
DESCRIPTION
The PCM codec is designed to perform transmit
encoding analog/digital (A/D) conversion, receive
decoding digital/analog (D/A) conversion, and transmit
and receive filtering for voice-band communications
systems. The device operates in either the 15-bit linear
or 8-bit companded (µ-law or A-Law) mode, which is
selectable through the I²C interface. The PCM codec
generates its own internal clocks from a 2.048-MHz
master clock input.
PBS PACKAGE
(TOP VIEW)
PLLV_DD
EARV_SS
EAR1ON
EARV_DD
EAR1OP
EARV_SS
EAR2O
AV_DD
24 23 22 21 20 19 18 17
25
16
26
15
27
14
28
13
29
12
30
11
31
10
32
9
1234567 8
PCMO
PCMI
DV_SS
DV_DD
SCL
SDA
NC
NC
NC − No internal connection
This device contains circuits to protect its inputs and outputs against damage due to high static voltages or electrostatic fields. These
circuits have been qualified to protect this device against electrostatic discharges (ESD) of up to 2 kV according to MIL-STD-883C,
Method 3015; however, it is advised that precautions be taken to avoid application of any voltage higher than maximum-rated
voltages to these high-impedance circuits. During storage or handling, the device leads should be shorted together or the device
should be placed in conductive foam. In a circuit, unused inputs should always be connected to an appropriated logic voltage level,
preferably either VCC or ground. Specific guidelines for handling devices of this type are contained in the publication Guidelines for
Handling Electrostatic-Discharge-Sensitive (ESDS) Devices and Assemblies available from Texas Instruments.
MicroStar Junior is a trademark of Texas Instruments.
All other trademarks are the property of their respective owners.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
Copyright  2001, Texas Instruments Incorporated
www.ti.com
1