SN75LVDS83C_17 Datasheet, PDF (1/29 Pages) Texas Instruments – FLATLINK TRANSMITTER

SN75LVDS83C
www.ti.com
SLLSE66A – OCTOBER 2010 – REVISED SEPTEMBER 2011
FLATLINK™ TRANSMITTER
Check for Samples: SN75LVDS83C
FEATURES
1
•2 LVDS Display Serdes Interfaces Directly to
LCD Display Panels with Integrated LVDS
• Package: 4.5mm x 7mm BGA
• 1.8V up to 3.3V Tolerant Data Inputs to
Connect Directly to Low-Power, Low-Voltage
Application and Graphic Processors
• Transfer Rate up to 85Mpps (Mega Pixel Per
Second); Pixel Clock Frequency Range 10MHz
to 85MHz
• Suited for Display Resolutions Ranging From
HVGA up to HD With Low EMI
• Operates From a Single 3.3V Supply and
148mW (typical) at 75MHz
• 28 Data Channels Plus Clock In Low-Voltage
TTL to 4 Data Channels Plus Clock Out
Low-Voltage Differential
• Consumes Less Than 1mW When Disabled
• Selectable Rising or Falling Clock Edge
Triggered Inputs
• ESD: 5kV HBM
• Support Spread Spectrum Clocking (SSC)
APPLICATIONS
• LCD Display Panel Driver
• UMPC and Netbook PC
• Digital Picture Frame
DESCRIPTION
The SN75LVDS83C FlatLink™ transmitter contains four 7-bit parallel-load serial-out shift registers, a 7X clock
synthesizer, and five Low-Voltage Differential Signaling (LVDS) line drivers in a single integrated circuit. These
functions allow 28 bits of single-ended LVTTL data to be synchronously transmitted over five balanced-pair
conductors for receipt by a compatible receiver, such as the SN75LVDS82 and LCD panels with integrated LVDS
receiver.
When transmitting, data bits D0 through D27 are each loaded into registers upon the edge of the input clock
signal (CLKIN). The rising or falling edge of the clock can be selected via the clock select (CLKSEL) pin. The
frequency of CLKIN is multiplied seven times, and then used to unload the data registers in 7-bit slices and
serially. The four serial streams and a phase-locked clock (CLKOUT) are then output to LVDS output drivers.
The frequency of CLKOUT is the same as the input clock, CLKIN.
Application
processor
(e.g. OMAP^TM)
SN75LVDS83C
FlatLink^TM Transmitter
swivel
BGA Package: 4.5 x 7mm
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
FlatLink is a trademark of Texas Instruments.
2
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2010–2011, Texas Instruments Incorporated