SN65LVDS151_08 Datasheet, PDF (1/13 Pages) Texas Instruments – MuxIt SERIALIZER-TRANSMITTER

SN65LVDS151
www.ti.com
MuxIt™ SERIALIZER-TRANSMITTER
SLLS444A – DECEMBER 2000
FEATURES
• A Member of the MuxIt™
Serializer-Deserializer Building-Block Chip
Family
• Supports Serialization of up to 10 Bits of
Parallel Data Input at Rates up to 200 Mbps
• PLL Lock/Valid Input Provided to Enable Link
Data Transfers
• Cascadable With Additional SN65LVDS151
MuxIt Serializer-Transmitters for Wider
Parallel Input Data Channel Widths
• LVDS Compatible Differential Inputs and
Outputs Meet or Exceed the Requirements of
ANSI TIA/EIA-644-A
• LVDS Inputs and Outputs ESD Protection
Exceeds 12 kV HBM
• LVTTL Compatible Inputs for Lock/Valid,
Enables, and Parallel Data Inputs Are 5-V
Tolerant
• Operates With 3.3 V Supply
• Packaged in 32-Pin DA Thin Shrink
Small-Outline Package With 26 Mil Terminal
Pitch
SN65LVDS151DA
(Marked as 65LVDS151)
V_{CC 1}
GND 2
LCRI+ 3
LCRI– 4
CI_EN 5
DI–9 6
DI–8 7
DI–7 8
DI–6 9
DI–5 10
DI–4 11
DI–3 12
DI–2 13
DI–1 14
DI–0 15
GND 16
32 ^CI–
31 ^CI+
30 ^LVI
29 ^MCI–
28 ^MCI+
27 ^GND
26 ^VCC
25 ^LCO+
24 ^LCO–
23 ^VCC
22 ^EN
21 ^LCO_EN
20 ^VCC5
19 ^GND
18 ^DO+
17 DO–
DESCRIPTION
MuxIt is a family of general-purpose, multiple-chip building blocks for implementing parallel data serializers and
deserializers. The system allows for wide parallel data to be transmitted through a reduced number of
transmission lines over distances greater than can be achieved with a single-ended (e.g., LVTTL or LVCMOS)
data interface. The number of bits multiplexed per transmission line is user-selectable and allows for higher
transmission efficiencies than with existing fixed ratio solutions. MuxIt utilizes the LVDS (TIA/EIA-644-A) low
voltage differential signaling technology for communications between the data source and data destination.
The MuxIt family initially includes three devices supporting simplex communications: the SN65LVDS150 phase
locked loop frequency multiplier, the SN65LVDS151 serializer-transmitter, and the SN65LVDS152
receiver-deserializer.
The SN65LVDS151 consists of a 10-bit parallel-in/serial-out shift register, three LVDS differential transmission
line receivers, a pair of LVDS differential transmission line drivers, plus associated input buffers. It accepts up to
10 bits of user data on parallel data inputs (DI-0 → DI-9) and serializes (multiplexes) the data for transmission
over an LVDS transmission line link. Two or more SN65LVDS151 units may be connected in series (cascaded)
to accommodate wider parallel data paths for higher serialization values. Data is transmitted over the LVDS
serial link at M times the input parallel data clock frequency. The multiplexing ratio M, or number of bits per data
clock cycle, is programmed on the companion SN65LVDS150 MuxIt programmable PLL frequency multiplier with
configuration pins (M1 → M5). The range of multiplexing ratio M supported by the SN65LVDS150 MuxIt
programmable PLL frequency multiplier is between 4 and 40. Table 1 shows some of the combinations of LCRI
and MCI supported by the SN65LVDS150 MuxIt programmable PLL frequency multiplier.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
MuxIt is a trademark of Texas Instruments.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2000, Texas Instruments Incorporated