S6E2HE4E0AGV20000 Datasheet, PDF (1/163 Pages) Texas Instruments – 32-bit ARM ® Cortex ® -M4F FM4 Microcontroller

S6E2H Series
®
®
32-bit ARM Cortex -M4F
FM4 Microcontroller
Devices in the S6E2H Series are highly integrated 32-bit microcontrollers with high performance and competitive cost. This series is
based on the ARM Cortex-M4F Processor with on-chip Flash memory and SRAM. The series has peripheral functions such as
Motor Control Timers, ADCs and Communication Interfaces (CAN, UART, CSIO, I²C, LIN).
SD Card Interface
Features
32-bit ARM Cortex-M4F Core
 Up to 160 MHz Frequency Operation
On-chip Memories
 MainFlash memory - Up to 512 Kbytes
 WorkFlash memory - 32 Kbytes
 SRAM
• SRAM0: Up to 32 Kbytes
• SRAM1: Up to 16 Kbytes
• SRAM2: Up to 16 Kbytes
External Bus Interface
CAN Interface (Max 2 channels)
Multi-function Serial Interface (Max 8 channels)
 Universal Asynchronous Receiver/Transmitter (UART)
 Clock Synchronous Serial Interface (CSIO (SPI))
 Local Interconnect Network (LIN)
 Inter-integrated Circuit (I²C)
DMA Controller (8 channels)
DSTC (Descriptor System data Transfer Controller) (256
channels)
A/D Converter (Max 24 channels)
[12-bit A/D Converter]
DA Converter (Max 2 channels)
Base Timer (Max 8 channels)
Up to 100 high-speed general-purpose I/O ports @ 120 pin
Package
Multi-function Timer (Max 3 units)
Real-time Clock (RTC)
Quadrature Position/Revolution Counter (QPRC) (Max 3
channels)
Dual Timer (32-/16-bit Down Counter)
Five clock sources (2 external oscillators, 2 internal CR
oscillator, and Main PLL) that are dynamically selectable.
 Main clock: 4 MHz to 48 MHz
 Sub Clock: 32.768 kHz
 High-speed internal CR Clock: 4 MHz
 Low-speed internal CR Clock: 100 kHz
 Main PLL Clock
 Resets
 Reset requests from INITX pin
 Power on reset
 Software reset
 Watchdog timers reset
 Low voltage detector reset
 Clock supervisor reset
Clock SuperVisor (CSV)
Low-Voltage Detector (LVD)
Low-power Consumption Modes
 Sleep
 Timer
 RTC
 Stop
 Deep standby RTC (selectable from with/without RAM
retention)
 Deep standby stop (selectable from with/without RAM
retention)
 VBAT
 Debug
 Serial Wire JTAG Debug Port (SWJ-DP)
 Embedded Trace Macrocells (ETM) provide
comprehensive debug and trace facilities.
Unique value of the device (41-bit) is set.
Power Supplies
 Wide range voltage:
 Power supply for VBAT:
VCC
VBAT
= 2.7 V to 5.5 V
= 2.7 V to 5.5 V
Watch Counter
External Interrupt Controller Unit
Watchdog Timer (2 channels)
CRC (Cyclic Redundancy Check) Accelerator
Cypress Semiconductor Corporation
Document Number:
• 198 Champion Court • San Jose, CA 95134-1709 • 408-943-2600
001-98943 Rev *C
Revised March 7, 2016