MSP430FE427 Datasheet, PDF (1/65 Pages) Texas Instruments – Mixed-Signal Microcontrollers

Product
Folder
Sample &
Buy
Technical
Documents
Tools &
Software
Support &
Community
MSP430FE427, MSP430FE425, MSP430FE423
SLAS396D – JULY 2003 – REVISED NOVEMBER 2016
MSP430FE42x Mixed-Signal Microcontrollers
1 Device Overview
1.1 Features
1
• Low Supply Voltage Range: 2.7 V to 3.6 V
• Ultra-Low Power Consumption:
– Active Mode: 400 µA at 1 MHz, 3 V
– Standby Mode: 1.6 µA
– Off Mode (RAM Retention): 0.1 µA
• Five Power-Saving Modes
• Wake up From Standby Mode in Less Than 6 µs
• Frequency-Locked Loop, FLL+
• 16-Bit RISC Architecture, 125-ns Instruction Cycle
Time
• Embedded Signal Processing for Single-Phase
Energy Metering With Integrated Analog Front End
and Temperature Sensor (ESP430CE1)
• 16-Bit Timer_A With Three Capture/Compare
Registers
• Integrated LCD Driver for 128 Segments
• Serial Communication Interface (USART),
Asynchronous UART or Synchronous SPI
Selectable by Software
• Brownout Detector
• Supply Voltage Supervisor and Monitor With
Programmable Level Detection
• Serial Onboard Programming, No External
Programming Voltage Needed, Programmable
Code Protection by Security Fuse
• Bootloader (BSL)
• Family Members Include:
– MSP430FE423
8KB + 256 B of Flash Memory, 256 B of RAM
– MSP430FE425
16KB + 256 B of Flash Memory, 512 B of RAM
– MSP430FE427
32KB + 256 B of Flash Memory, 1KB of RAM
• Available in 64-Pin Quad Flat Pack (LQFP)
• For Complete Module Descriptions, See the
MSP430x4xx Family User's Guide
1.2 Applications
• 2-Wire and 3-Wire Single-Phase Meters
• Tamper-Resistant Meters
1.3 Description
The TI MSP430™ family of ultra-low-power microcontrollers consists of several devices featuring different
sets of peripherals targeted for various applications. The architecture, combined with five low-power
modes, is optimized to achieve extended battery life in portable measurement applications. The device
features a powerful 16-bit RISC CPU, 16-bit registers, and constant generators that contribute to
maximum code efficiency. The digitally controlled oscillator (DCO) allows the device to wake up from low-
power modes to active mode in less than 6 µs.
The MSP430FE42x series are microcontroller configurations with three independent 16-bit sigma-delta
ADCs and an embedded signal processor core used to measure and calculate single-phase energy in
both 2-wire and 3-wire configurations. Also included are a built-in 16-bit timer, 128-segment LCD drive
capability, and 14 I/O pins.
Typical applications include 2-wire and 3-wire single-phase metering including tamper-resistant meter
implementations.
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.