LMX5452 Datasheet, PDF (1/10 Pages) National Semiconductor (TI) – Micro-Module Integrated Bluetooth-R 1.2 Baseband Controller and Radio

NRND
LMX5452
www.ti.com
SNOSAU1A – FEBRUARY 2006 – REVISED MARCH 2013
Micro-Module Integrated Bluetooth^® 1.2 Baseband Controller and Radio
Check for Samples: LMX5452
FEATURES
1
•23 Compliant with the Bluetooth 1.2 Core
Specification
• -80 dBm Receiver Sensitivity (Typical)
• Class 2 Operation
• Low Power Consumption:
– Advanced Power Management Features
– Clocking Option 12/13 MHz with PLL
Bypass Mode for Power Reduction
• High integration:
– Implemented in 0.18 μm CMOS Technology
– RF Includes On-chip Antenna Filter and
Switch
– On-chip Firmware with Complete HCI
• Embedded ROM and Patch RAM Memory
• Up to Seven Asynchronous Connection Less
(ACL) Links
• Support for Two Simultaneous Voice or
Synchronous Connection Oriented (SCO)
Links
• Accepts10-20 MHz External Clock or Crystal
Network
• Fractional-N Sigma/Delta Modulator
• Operating Voltage Range 2.5–3.6V
• I/O Voltage Range 1.6–3.6V
• 60-pad micro-module NFBGA package (6.1 mm
× 9.1 mm × 1.2 mm)
APPLICATIONS
• Mobile Handsets
• USB Dongles
• Stereo Headsets
• Personal Digital Assistants
• Personal Computers
• Automotive Telematics
INTERFACES
• Full-duplex UART Supporting Transfer Rates
up to 921.6 kbps Including Baud Rate
Detection for HCI
• Full Speed (12 Mbps) USB 2.0 for HCI
• ACCESS.bus and SPI/Microwire for Interfacing
with External Non-volatile Memory
• Advanced Audio Interface (AAI) for Interfacing
with External 8-kHz PCM Codec
• Up to 3 GPIO port Pins (OP4/PG4, PG6, PG7)
Controllable by HCI Commands
• JTAG Based Serial On-chip Debug Interface
• Single Rx/Tx-pad Radio Interface
DESCRIPTION
The LMX5452 is a highly integrated Bluetooth 1.2
compliant solution. The integrated baseband
controller and 2.4 GHz radio combine to form a
complete, small form-factor (6.1 mm × 9.1 mm × 1.2
mm) Bluetooth node.
The baseband controller has a standard Host
Controller Interface (HCI). Based on the Texas
Instruments CompactRISCTM 16-bit processor, the
LMX5452 is optimized to handle the audio, data, and
link management processing requirements of a
Bluetooth node.
The on-chip memory, ROM, and Patch RAM provide
lowest cost and minimize design risk with the
flexibility of firmware upgrades.
The firmware supplied in the on-chip ROM supports a
complete Bluetooth Link Manager and HCI with
communication through a UART or USB interface.
This firmware features point-to-point and point-to-
multipoint link management, supporting data rates up
to 723 kbps.
The radio employs an integrated antenna filter and
switch to minimize the number of external
components.
The radio has a heterodyne receiver architecture with
a low intermediate frequency (IF), which enables the
IF filters to be integrated on-chip. The transmitter
uses direct IQ-modulation with Gaussian-filtered bit-
stream data, a voltage-controlled oscillator (VCO)
buffer, and a power amplifier.
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
Bluetooth is a registered trademark of Bluetooth SIG, Inc.
2
All other trademarks are the property of their respective owners.
3
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2006–2013, Texas Instruments Incorporated