LM10 Datasheet, PDF (1/37 Pages) National Semiconductor (TI) – Operational Amplifier and Voltage Reference

Product
Folder
Sample &
Buy
Technical
Documents
Tools &
Software
Support &
Community
LM10
SNOSBH4E – MAY 1998 – REVISED OCTOBER 2015
LM10 Operational Amplifier and Voltage Reference
1 Features
•1 Input Offset Voltage: 2 mV (Maximum)
• Input Offset Current: 0.7 nA (Maximum)
• Input Bias Current: 20 nA (Maximum)
• Reference Regulation: 0.1% (Maximum)
• Offset Voltage Drift: 2 μV/°C
• Reference Drift: 0.002%/°C
2 Applications
• Remote Amplifiers
• Battery-Level Indicators
• Thermocouple Transmitters
• Voltage and Current regulators
3 Description
The LM10 series are monolithic linear ICs consisting
of a precision reference, an adjustable reference
buffer and an independent, high-quality operational
amplifier.
The unit can operate from a total supply voltage as
low as 1.1 V or as high as 40 V, drawing only 270 μA.
A complementary output stage swings within 15 mV
of the supply terminals or will deliver ±20-mA output
current with ±0.4-V saturation. Reference output can
be as low as 200 mV.
The circuit is recommended for portable equipment
and is completely specified for operation from a
single power cell. In contrast, high output-drive
capability, both voltage and current, along with
thermal overload protection, suggest it in demanding
general-purpose applications.
The device is capable of operating in a floating mode,
independent of fixed supplies. It can function as a
remote comparator, signal conditioner, SCR controller
or transmitter for analog signals, delivering the
processed signal on the same line used to supply
power. It is also suited for operation in a wide range
of voltage and current regulator applications, from low
voltages to several hundred volts, providing greater
precision than existing ICs.
This series is available in the three standard
temperature ranges, with the commercial part having
relaxed limits. In addition, a low-voltage specification
(suffix L) is available in the limited temperature
ranges at a cost savings.
Device Information⁽¹⁾
PART NUMBER
PACKAGE
BODY SIZE (NOM)
SOIC (14)
8.992 mm × 7.498 mm
LM10
SDIP (8)
8.255 mm × 8.255 mm
PDIP (8)
9.81 mm × 6.35 mm
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
Operational Amplifier Schematic
(Pin numbers are for 8-pin packages)
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.