LF298-MIL Datasheet, PDF (1/28 Pages) Texas Instruments – Monolithic Sample-and-Hold Circuits

Product
Folder
Order
Now
Technical
Documents
Tools &
Software
Support &
Community
LF298-MIL Monolithic Sample-and-Hold Circuits
LF298-MIL
SNOSD57 – JUNE 2017
1 Features
•1 Operates from ±5-V to ±18-V Supplies
• Less than 10-μs Acquisition Time
• Logic Input Compatible With TTL, PMOS, CMOS
• 0.5-mV Typical Hold Step at Ch = 0.01 µF
• Low Input Offset
• 0.002% Gain Accuracy
• Low Output Noise in Hold Mode
• Input Characteristics Do Not Change During Hold
Mode
• High Supply Rejection Ratio in Sample or Hold
• Wide Bandwidth
• Space Qualified, JM38510
2 Applications
• Ramp Generators With Variable Reset Level
• Integrators With Programmable Reset Level
• Synchronous Correlators
• 2-Channel Switches
• DC and AC Zeroing
• Staircase Generators
3 Description
The LF298-MIL devices are monolithic sample-and-
hold circuits that use BI-FET technology to obtain
ultrahigh DC accuracy with fast acquisition of signal
and low droop rate. Operating as a unity-gain
follower, DC gain accuracy is 0.002% typical and
acquisition time is as low as 6 µs to 0.01%. A bipolar
input stage is used to achieve low offset voltage and
wide bandwidth. Input offset adjust is accomplished
with a single pin and does not degrade input offset
drift. The wide bandwidth allows the LF298-MIL to be
included inside the feedback loop of 1-MHz
operational amplifiers without having stability
problems. Input impedance of 10¹⁰ Ω allows high-
source impedances to be used without degrading
accuracy.
P-channel junction FETs are combined with bipolar
devices in the output amplifier to give droop rates as
low as 5 mV/min with a 1-µF hold capacitor. The
JFETs have much lower noise than MOS devices
used in previous designs and do not exhibit high
temperature instabilities. The overall design ensures
no feedthrough from input to output in the hold mode,
even for input signals equal to the supply voltages.
Logic inputs on the LF298-MIL are fully differential
with low input current, allowing for direct connection
to TTL, PMOS, and CMOS. Differential threshold is
1.4 V. The LF298-MIL will operate from ±5-V to ±18-V
supplies.
An A version is available with tightened electrical
specifications.
Typical Connection
Device Information⁽¹⁾
PART NUMBER
PACKAGE
BODY SIZE (NOM)
LF298-MIL
SOIC (14)
TO-99 (8)
8.65 mm × 3.91 mm
9.08 mm × 9.08 mm
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
Acquisition Time
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.