CDCLVC1310_14 Datasheet, PDF (1/30 Pages) Texas Instruments – Ten-Output Low-Jitter Low-Power Clock Buffer and Level Translator

CDCLVC1310
www.ti.com
SCAS917E – JULY 2011 – REVISED JANUARY 2014
Ten-Output Low-Jitter Low-Power Clock Buffer and Level Translator
Check for Samples: CDCLVC1310
FEATURES
1
• High-Performance Crystal Buffer With Ultralow
Noise Floor of –169 dBc/Hz
• Additive Phase Noise/Jitter Performance Is
25 fs_RMS (Typ.)
• Level Translation With 3.3-V or 2.5-V Core and
3.3-V, 2.5-V, 1.8-V, or 1.5-V Output Supply
• Device inputs consist of primary, secondary,
and crystal inputs, and manually selectable
(through pins) using the input MUX. The
primary and secondary inputs can accept
LVPECL, LVDS, HCSL, SSTL or LVCMOS
signals and crystal input.
– Crystal Frequencies Supported Are From
8 MHz to 50 MHz
– Differential and Single-Ended Input
Frequencies Supported Are up to 200 MHz
• 10 Single-Ended LVCMOS Outputs. The
outputs can operate at 1.5-V, 1.8-V, 2.5-V or
3.3-V Power-Supply Voltage.
– LVCMOS Outputs Operate up to 200 MHz
– Output Skew Is 30 ps (Typical)
– Total Propagation Delay Is 2 ns (Typical)
– Synchronous and Glitch-Free Output
Enable Is Available
• Offered in QFN-32 5-mm × 5-mm Package With
Industrial Temperature Range of –40°C to 85°C
• Can Overdrive Crystal Input With LVCMOS
Signal up to 50 MHz
APPLICATIONS
• Wireless and Wired Infrastructure
• Networking and Data Communications
• Medical Imaging
• Portable Test and Measurement
• High-End A/V
DESCRIPTION
The CDCLVC1310 is a highly versatile, low-jitter, low-
power clock fanout buffer which can distribute to ten
low-jitter LVCMOS clock outputs from one of three
inputs, whose primary and secondary inputs can
feature differential or single-ended signals and crystal
input. Such a buffer is good for use in a variety of
mobile and wired infrastructure, data communication,
computing, low-power medical imaging, and portable
test and measurement applications. When the input is
an illegal level, the output is at a defined state. One
can set the core to 2.5 V or 3.3 V, and output to 1.5
V, 1.8 V, 2.5 V or 3.3 V. Pin programming easily
configures the CDCLVC1310. The overall additive
jitter performance is 25 fs_RMS (typical). The
CDCLVC1310 comes in a small 32-pin 5-mm × 5-mm
QFN package.
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2011–2014, Texas Instruments Incorporated