BQ24750_14 Datasheet, PDF (1/39 Pages) Texas Instruments – AC Overpower Protection

bq24750
www.ti.com............................................................................................................................................... SLUS735D – DECEMBER 2006 – REVISED MARCH 2009
Host-Controlled Multi-Chemistry Battery Charger With Integrated System Power Selector
and AC Overpower Protection
FEATURES
1
• NMOS-NMOS Synchronous Buck Converter
with 300 kHz Frequency and >95% Efficiency
• 30-ns Minimum Driver Dead-time and 99.5%
Maximum Effective Duty Cycle
• High-Accuracy Voltage and Current Regulation
– ±0.5% Charge Voltage Accuracy
– ±3% Charge Current Accuracy
– ±3% Adapter Current Accuracy
– ±2% Input Current Sense Amp Accuracy
• Integration
– Automatic System Power Selection From
AC/DC Adapter or Battery
– Internal Loop Compensation
– Internal Soft Start
• Safety
– Input Overvoltage Protection (OVP)
– Dynamic Power Management (DPM) with
Status Indicator
– Programmable Inrush Adapter Power
(ACOP) and Overcurrent (ACOC) Limits
– Reverse-Conduction Protection Input FET
– Battery Thermistor Sense Input (TS) for
Charge Qualification
• Supports Two, Three, or Four Li+ Cells
• 5–24 V AC/DC-Adapter Operating Range
• Analog Inputs with Ratiometric Programming
via Resistors or DAC/GPIO Host Control
– Charge Voltage (4–4.512 V/cell)
– Charge Current (up to 10 A, with 10-mΩ
Sense Resistor)
– Adapter Current Limit (DPM)
• Status and Monitoring Outputs
– AC/DC Adapter Present with Programmable
Voltage Threshold
– DPM Loop Active
– Current Drawn from Input Source
• Supports Any Battery Chemistry: Li+, NiCd,
NiMH, Lead Acid, etc.
• Charge Enable
• 10-µA Off-State Current
• 28-pin, 5x5-mm QFN package
APPLICATIONS
• Notebook and Ultra-Mobile Computers
• Portable Data-Capture Terminals
• Portable Printers
• Medical Diagnostics Equipment
• Battery Bay Chargers
• Battery Back-up Systems
DESCRIPTION
The bq24750 is a high-efficiency, synchronous
battery charger with integrated compensation and
system power selector logic, offering low component
count for space-constrained multi-chemistry battery
charging applications. Ratiometric charge current and
voltage programming allows high regulation
accuracies, and can be either hardwired with resistors
or programmed by the system power-management
microcontroller using a DAC or GPIOs.
CHGEN
ACN
ACP
ACDRV
ACDET
ACSET
ACOP
28 27 26 25 24 23 22
1
21
2
20
3
bq24750
19
4
28 LD QFN
18
TOP VIEW
5
17
6
16
7
15
8 9 10 11 12 13 14
DPMDET
CELLS
SRP
SRN
BAT
SRSET
IADAPT
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2006–2009, Texas Instruments Incorporated