20413 Datasheet, PDF (6/6 Pages) Texas Instruments – Snap-Action Automatic and Manual reset Fixed Temperature Thermostats

To facilitate processing your request, please fax this page to our Product Specialists.
To: Marketing Dept.
Texas Instruments
Attleboro, MA 02703
Phone: [phone]
[phone]
Fax: [phone]
From ________________________________________________________
Company_____________________________________________________
Address______________________________________________________
Phone _____________________
Fax _______________________
The following information will help us determine the correct thermostat design for your application. You
may refer to the charts on pages 2 and 3 for assistance.
Request: Pricing _____________________________ Application Assistance _________________________
Description of Application ______________________________________________________________________
Estimated Annual Usage _______________________________________________________________________
Automatic Reset_______ MR________ MR-TF________ SPST________ SPDT________ DPST________
Open Temperature ____________________________ Maximum Tolerance ___________________________
Close Temperature ___________________________ Maximum Tolersnce ___________________________
Temperature Exposures: Maximum __________________________ Minimum _________________________
Location With Respect to Heat Source ___________________________________________________________
Temperature Transfer Medium (air, metal surface, etc.)_____________________________________________
Type of Heat Source: Convection _____________ Conduction ____________ Radiation ____________
Electrical Requirements: __________________ Amps @ _________________ Volts; AC or DC ___________
Resistive ___________________ Inductive ___________________* Capacitive ___________________*
Tungsten Filament __________________ Milliamp _________________ Pilot Duty _________________
*If inductive or capacitive, indicate power factor __________________________________________________
(If available, please send copy of electrical / plumbing diagram).
Switch Termination (type and angle)_____________________________________________________________
Flange (type and angle of rotation) ______________________________________________________________
Enclosed or Exposed Disc ______________________________________________________________________
Environment (dust, lint, chemical fumes, etc.) ____________________________________________________
_____________________________________________________________________________________________
Agency Approvals _____________________________________________________________________________
Printed in U.S.A.
Reprinted 4/2002
MCGS011A