TLC271_01 Datasheet, PDF (57/82 Pages) Texas Instruments – LinCMOSE PROGRAMMABLE LOW-POWER OPERATIONAL AMPLIFIERS

TLC271, TLC271A, TLC271B
LinCMOS PROGRAMMABLE LOW-POWER
OPERATIONAL AMPLIFIERS
SLOS090D – NOVEMBER 1987 – REVISED MARCH 2001
APPLICATION INFORMATION
single-supply operation (continued)
Many single-supply applications require that a voltage be applied to one input to establish a reference level that
is above ground. A resistive voltage divider is usually sufficient to establish this reference level (see Figure 103).
The low input bias current consumption of the TLC271 permits the use of very large resistive values to
implement the voltage divider, thus minimizing power consumption.
The TLC271 works well in conjunction with digital logic; however, when powering both linear devices and digital
logic from the same power supply, the following precautions are recommended:
1. Power the linear devices from separate bypassed supply lines (see Figure 104); otherwise, the linear device
supply rails can fluctuate due to voltage drops caused by high switching currents in the digital logic.
2. Use proper bypass techniques to reduce the probability of noise-induced errors. Single capacitive
decoupling is often adequate; however, RC decoupling may be necessary in high-frequency applications.
OUT
Logic
Logic
Logic
Power
Supply
(a) COMMON SUPPLY RAILS
OUT
Logic
Logic
Logic
Power
Supply
(b) SEPARATE BYPASSED SUPPLY RAILS (preferred)
Figure 104. Common Versus Separate Supply Rails
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
57