SN75ALS194NSR Datasheet, PDF (4/22 Pages) Texas Instruments – QUADRUPLE DIFFERENTIAL LINE DRIVERS

SN55ALS194, SN75ALS194
QUADRUPLE DIFFERENTIAL LINE DRIVERS
SLLS009D – OCTOBER 1985 – REVISED MAY 1995
electrical characteristics over recommended ranges of supply voltage and operating free-air
temperature range (unless otherwise noted)
PARAMETER
TEST CONDITIONS†
MIN
TYP‡ MAX UNIT
VIK
Input clamp voltage
VOH High-level output voltage
VOL
VO
|VOD1|
Low-level output voltage
Output voltage
Differential output voltage
|VOD2| Differential output voltage
VCC = MIN,
VCC = MIN,
IOH = –20 mA
VCC = MIN,
IO = 0
IO = 0
II = – 18 mA
SN55ALS194
SN75ALS194
IOL = MAX
2.4
2.5
0
1.5
1/2 VOD1
or 2§
– 1.5 V
V
0.5 V
6V
6V
V
∆|VOD|
Change in magnitude of
differential output voltage¶
VOC
∆|VOC|
Common-mode output voltage
Change in magnitude of
common-mode output voltage¶
RL = 100 Ω,
See Figure 1
± 0.4 V
±3 V
± 0.4 V
IO
Output current with power off
VCC = 0
VO = 6 V
VO = – 0.25 V
IOZ
High-impedance-state output current
VCC = MAX,
Output enables at 0.8 V
VO = 2.7 V
VO = 0.5 V
100
µA
– 100
100
µA
– 100
II
Input current at maximum input voltage VCC = MAX,
VI = 5.5 V
100 µA
IIH
High-level input current
VCC = MAX,
VI = 2.7 V
50 µA
IIL
Low-level input current
IOS
Short-circuit output current#
VCC = MAX,
VCC = MAX,
VI = 0.5 V
VI = 2 V
– 200 µA
– 40
– 140 mA
ICC
Supply current (all drivers)
VCC = MAX,
All outputs disabled
26 45 mA
† _{For conditions shown as MIN or MAX, use the appropriate value specified under recommended operating conditions.}
‡ _{All typical values are at VCC = 5 V, TA = 25°C.}
§ _{The minimum VOD2 with a 100-Ω load is either 1/2 VOD1 or 2 V, whichever is greater.}
¶ _{∆ | VOD | and ∆ | VOC | are the changes in magnitude of VOD and VOC, respectively, that occur when the input is changed from a high level to}
a low level.
# _{Not more than one output should be shorted at a time, and duration of the short circuit should not exceed one second.}
switching characteristics, V_CC = 5 V, T_A = 25°C
PARAMETER
TEST
CONDITIONS
tPLH
tPHL
Propagation delay time, low- to high-level output
Propagation delay time, high- to low-level output
Output-to-output skew
tt(OD) Differential output transition time
tPZH
tPZL
tPHZ
tPLZ
Output enable time to high level
Output enable time to low level
Output disable time from high level
Output disable time from low level
CL = 15 pF,
See Figure 2
CL = 15 pF,
See Figure 3
CL = 15 pF,
See Figure 4
SN55ALS194
MIN TYP MAX
6
13
9
14
3.5
6
8
14
9
12
12
20
9
15
12
15
SN75ALS194
MIN TYP MAX
6
13
9
14
3.5
6
UNIT
ns
ns
ns
8
14 ns
9
12 ns
12
20 ns
9
14 ns
12
15 ns
4
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265