SN751178NSR Datasheet, PDF (4/16 Pages) Texas Instruments – DUAL DIFFERENTIAL DRIVERS AND RECEIVERS

SN751177, SN751178
DUAL DIFFERENTIAL DRIVERS AND RECEIVERS
SLLS059D – FEBRUARY 1990 – REVISED MAY 1999
schematics of outputs
TYPICAL OF ALL DRIVER OUTPUTS
VCC
TYPICAL OF ALL RECEIVER OUTPUTS
VCC
85 Ω
NOM
Output
Output
GND
All resistor values are nominal.
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)^†
Supply voltage, V_CC (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 V
Input voltage, V_I (DE, RE, and D inputs) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 V
Receiver input voltage range, V_I (A or B inputs) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –25 V to 25 V
Receiver differential input voltage range, V_ID (see Note 2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –25 V to 25 V
Driver output voltage range, V_O . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –10 V to 15 V
Receiver low-level output current, I_OL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 mA
Package thermal impedance, θ_JA (see Note 3): N package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 78°C/W
NS package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 111°C/W
Storage temperature range, T_stg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –65°C to 150°C
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260°C
† _{Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and}
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. All voltage values, except differential input voltage, are with respect to the network ground terminal.
2. Differential input voltage is measured at the noninverting terminal with respect to the inverting terminal.
3. The package thermal impedance is calculated in accordance with JESD 51, except for through-hole packages, which use a trace
length of zero.
4
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265