|
LMV821 Datasheet, PDF (4/31 Pages) National Semiconductor (TI) – Low Voltage, Low Power, R-to-R Output, 5 MHz Op Amps | |||
|
◁ |
LMV821 SINGLE, LMV822 DUAL, LMV824 QUAD
LOW-VOLTAGE RAIL-TO-RAIL OUTPUT OPERATIONAL AMPLIFIERS
SLOS434G â FEBRUARY 2004 â REVISED AUGUST 2005
Absolute Maximum Ratings(1)
over operating free-air temperature range (unless otherwise noted)
www.ti.com
VCC Supply voltage(2)
VID Differential input voltage(3)
VI Input voltage range (either input)
Duration of output short circuit (one amplifier) to ground(4)
θJA Package thermal impedance(5)(6)
TJ Operating virtual junction temperature
Tstg Storage temperature range
At or below TA = 25°C, VCC ⤠5.5 V
D package
8 pin
14 pin
DBV package
DCK package
DGK package
DGV package
PW package
MIN
MAX
5.5
±VCC
VCCâ
VCC+
Unlimited
97
86
206
252
172
127
113
150
â65
150
UNIT
V
V
V
°C/W
°C
°C
(1) Stresses beyond those listed under âabsolute maximum ratingsâ may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under ârecommended operating
conditionsâ is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltage values (except differential voltages and VCC specified for the measurement of IOS) are with respect to the network GND.
(3) Differential voltages are at IN+ with respect to INâ.
(4) Short circuits from outputs to VCC can cause excessive heating and eventual destruction.
(5) Maximum power dissipation is a function of TJ(max), θJA, and TA. The maximum allowable power dissipation at any allowable ambient
temperature is PD = (TJ(max) â TA)/θJA. Operating at the absolute maximum TJ of 150°C can affect reliability.
(6) The package thermal impedance is calculated in accordance with JESD 51-7.
Recommended Operating Conditions
VCC Supply voltage (single-supply operation)
TA Operating free-air temperature
LMV8xxI
LMV8xx
MIN
MAX UNIT
2.5
5V
â40
125
°C
â40
85
4
|
▷ |