SN74LVC1G06_08 Datasheet, PDF (3/17 Pages) Texas Instruments – SINGLE INVERTER BUFFER/DRIVER WITH OPEN-DRAIN OUTPUT

www.ti.com
Absolute Maximum Ratings⁽¹⁾
over operating free-air temperature range (unless otherwise noted)
SN74LVC1G06
SINGLE INVERTER BUFFER/DRIVER
WITH OPEN-DRAIN OUTPUT
SCES295T – JUNE 2000 – REVISED JANUARY 2007
V_CC
Supply voltage range
V_I
Input voltage range⁽²⁾
V_O
Voltage range applied to any output in the high-impedance or power-off state⁽²⁾
V_O
Voltage range applied to any output in the high or low state⁽²⁾⁽³⁾
I_IK
Input clamp current
V_I < 0
I_OK
Output clamp current
V_O < 0
I_O
Continuous output current
Continuous current through V_CC or GND
DBV package
DCK package
θ_JA
Package thermal impedance⁽⁴⁾
DRL package
YZP package
YZV package
T_stg
Storage temperature range
MIN MAX UNIT
–0.5 6.5 V
–0.5 6.5 V
–0.5 6.5 V
–0.5 6.5 V
–50 mA
–50 mA
±50 mA
±100 mA
206
252
142 °C/W
132
123
–65 150 °C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) The input and output negative-voltage ratings may be exceeded if the input and output current ratings are observed.
(3) The value of V_CC is provided in the recommended operating conditions table.
(4) The package thermal impedance is calculated in accordance with JESD 51-7.
Submit Documentation Feedback
3