SN74CBT16233 Datasheet, PDF (3/5 Pages) Texas Instruments – 16-BIT 1-OF-2 FET MULTIPLEXER/DEMULTIPLEXER

SN74CBT16233
16-BIT 1-OF-2 FET MULTIPLEXER/DEMULTIPLEXER
SCDS010H – MAY 1995 – REVISED OCTOBER 1998
electrical characteristics over recommended operating free-air temperature range (unless
otherwise noted)
PARAMETER
TEST CONDITIONS
MIN TYP† MAX UNIT
VIK
VCC = 4.75 V,
II = –18 mA
–1.2 V
II
VCC = 0,
VCC = 5.25 V,
VI = 5.25 V
VI = 5.25 V or GND
10 µA
±1 µA
ICC
∆ICC‡
VCC = 5.25 V,
Control inputs VCC = 5.5 V,
IO = 0,
One input at 3.4 V,
VI = VCC or GND
Other inputs at VCC or GND
3 µA
2.5 mA
Ci
Control inputs VI = 3 V or 0
4.5
pF
Cio(OFF)
VO = 3 V or 0
4
pF
ron§
VCC = 4.75 V
VI = 0
II = 64 mA
II = 30 mA
5
7
5
7Ω
VI = 2.4 V,
II = 15 mA
7
12
† _{All typical values are at VCC = 5 V, TA = 25°C.}
‡ _{This is the increase in supply current for each input that is at the specified TTL voltage level rather than VCC or GND.}
§ _{Measured by the voltage drop between A and B terminals at the indicated current through the switch. On-state resistance is determined by the}
lower of the voltages of the two (A or B) terminals.
switching characteristics over recommended operating free-air temperature range, C_L = 50 pF
(unless otherwise noted) (see Figure 1)
PARAMETER
FROM
(INPUT)
TO
(OUTPUT)
MIN MAX UNIT
tpd¶
A or B
B or A
0.25 ns
tpd
SEL
A
1.6 5.3 ns
ten
TEST or SEL
B
1.3 5.2 ns
tdis
TEST or SEL
B
1 5.3 ns
¶ _{The propagation delay is the calculated RC time constant of the typical on-state resistance of the switch and the specified load capacitance, when}
driven by an ideal voltage source (zero output impedance).
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
3