SN65LVDM31 Datasheet, PDF (3/7 Pages) Texas Instruments – HIGH-SPEED DIFFERENTIAL LINE DRIVER

SN65LVDM31
HIGH-SPEED DIFFERENTIAL LINE DRIVER
SLLS417 – MARCH 2000
electrical characteristics over recommended operating conditions (unless otherwise noted)
PARAMETER
|VOD|
Differential output voltage magnitude
∆|VOD|
VOC(SS)
∆VOC(SS)
VOC(PP)
Change in differential output voltage magnitude
between logic states
Steady-state common-mode output voltage
Change in steady-state common-mode output
voltage between logic states
Peak-to-peak common-mode output voltage
ICC
Supply current
IIH
High-level input current
IIL
Low-level input current
IOS
Short-circuit output current
IOZ
High-impedance state output current
IO(OFF) Power-off output current
† _{All typical values are at 25°C and with a 3.3 V supply.}
TEST CONDITIONS
RL = 100 Ω,
RL = 50 Ω,
See Figure 2
See Figure 2
See Figure 2
See Figure 3
Enabled, No load
Enabled,
RL = 100 Ω
Disabled
VIH = 3 V
VIL = 0 V
VOY or VOZ = 0 V
VOD = 0 V
VO = 0 V or VCC
VCC = 1.5 V,
VIN = 0 or VCC
VO = 3.6 V
MIN TYP†
540 700
270 350
MAX
860
430
UNIT
mV
–25
0
25 mV
1.14 1.2 1.3 V
–30
0
30
mV
70 100
6
10
35
40 mA
0.5 0.7
–10
3
10 µA
–10
0
10 µA
7
10
mA
7
10
±1 µA
±1 µA
switching characteristics over recommended operating conditions (unless otherwise noted)
PARAMETER
TEST CONDITIONS
MIN TYP MAX UNIT
tPLH
tPHL
tr
tf
tsk(p)
tsk(o)
tsk(pp)
tPZH
tPZL
tPHz
tPLZ
NOTES:
Propagation delay time, low-to-high-level output
1.8 2.3 2.9 ns
Propagation delay time, high-to-low-level output
1.8 2.3 2.9 ns
Differential output signal rise time
Differential output signal fall time
See Figure 4
0.4 0.6 1.0 ns
0.4 0.6 1.0 ns
Pulse skew (|tPHL – tPLH|)
Channel-to-channel output skew (see Note 3)
50 350 ns
200 ns
Part-to-part skew (see Note 4)
1 ns
Propagation delay time, high-impedance-to-high-level output
6
15 ns
Propagation delay time, high-impedance-to-low level output
See Figure 5
6
15 ns
Propagation delay time, high-level-to-high-impedance output
6
15 ns
Propagation delay time, low-level-to-high-impedance output
6
15 ns
3. tsk(o) is the maximum delay time difference between drivers on the same device.
4. tsk(pp) is the magnitude of the difference in propagation delay times between any specified terminals of two devices when both
devices operate with the same supply voltages, at the same temperature, and have identical packages and test circuits.
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
3