LP239_06 Datasheet, PDF (3/10 Pages) Texas Instruments – LOW-POWER QUAD DIFFERENTIAL COMPARATORS

The LP239 is obsolete
and is no longer supplied.
recommended operating conditions
VCC Supply voltage
VIC Common-mode input voltage
VI Input voltage
TA Operating free-air temperature
LP239, LP339, LP2901
LOWĆPOWER QUAD DIFFERENTIAL COMPARATORS
SLCS004B − OCTOBER 1987 − REVISED SEPTEMBER 2004
VCC = 5 V
VCC = 30 V
VCC = 5 V
VCC = 30 V
LP239
MIN MAX
3
30
0
3
0
28
0
3
0
28
−25
85
LP339
MIN MAX
3
30
0
3
0
28
0
3
0
28
0
70
LP2901
MIN MAX
3
30
0
3
0
28
0
3
0
28
−40
85
UNIT
V
V
V
V
V
°C
electrical characteristics, V_CC = 5 V, T_A = 25°C (unless otherwise noted)
PARAMETER
VIO Input offset voltage
TEST CONDITIONS
VCC = 5 V to 30 V,
RS = 0,
VO = 2 V,
See Note 6
TA†
25°C
Full range
MIN
TYP MAX UNIT
±2
±5
mV
±9
IIO Input offset current
25°C
Full range
±0.5 ±5
nA
±1 ±15
IIB
Input bias current
See Note 7
25°C
Full range
−2.5 −25
nA
−4 −40
Common-mode input voltage
VICR _range
Single supply
25°C
0 to
VCC − 1.5
V
0 to
Full range
VCC − 2
AVD
Large-signal differential voltage
amplification
VCC = 15 V,
RL = 15 kΩ
500
V/mV
Output sink current
VI− = 1 V,
VI+ = 0
VO = 2 V,
25°C
20
30
See Note 8
Full range
15
mA
VO = 0.4 V
25°C
0.2
0.7
Output leakage current
VI+ = 1 V,
VI− = 0
VO = 5 V
VO = 30 V
25°C
Full range
0.1
nA
1 µA
VID Differential input voltage
VI ≤ 0 (or VCC _− on split supplies)
36
V
ICC Supply current
RL = ∞ all comparators
60 100 µA
† _{Full range is −25°C to 85°C for the LP239, 0°C to 70°C for the LP339, and − 40°C to 85°C for the LP2901.}
NOTES: 8. VIO is measured over the full common-mode input voltage range.
9. Because of the p-n-p input stage, the direction of the current is out of the device. This current essentially is constant (i.e., independent
of the output state). No loading change exists on the reference or input lines as long as the common-mode input voltage range is
not exceeded.
10. The output sink current is a function of the output voltage. These devices have a bimodal output section that allows them to sink
(via a Darlington connection) large currents at output voltages greater than 1.5 V, and smaller currents at output voltages
less than 1.5 V.
switching characteristics, V_CC = 5 V, T_A = 25°C, R_L connected to 5 V through 5.1 kΩ
PARAMETER
TEST CONDITIONS
MIN TYP MAX
Large-signal response time
1.3
Response time
TTL logic swing, Vref = 1.4 V
8
UNIT
µs
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
3