LM2675M-33 Datasheet, PDF (3/30 Pages) Texas Instruments – LM2675 SIMPLE SWITCHER Power Converter High Efficiency 1A Step-Down Voltage

LM2675
www.ti.com
SNVS129E – MAY 2004 – REVISED JUNE 2005
Absolute Maximum Ratings⁽¹⁾⁽²⁾
Supply Voltage
ON/OFF Pin Voltage
Switch Voltage to Ground
Boost Pin Voltage
Feedback Pin Voltage
ESD Susceptibility
Human Body Model⁽³⁾
Power Dissipation
Storage Temperature Range
Lead Temperature
D Package
Vapor Phase (60s)
Infrared (15s)
P Package (Soldering, 10s)
WSON Package (See AN-1187 - SNOA401)
Maximum Junction Temperature
45V
−0.1V ≤ V_SH ≤ 6V
−1V
V_SW + 8V
−0.3V ≤ V_FB ≤ 14V
2 kV
Internally Limited
−65°C to +150°C
+215°C
+220°C
+260°C
+150°C
(1) Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for
which the device is intended to be functional, but device parameter specifications may not be ensured under these conditions. For
ensured specifications and test conditions, see the Electrical Characteristics.
(2) If Military/Aerospace specified devices are required, please contact the Texas Instruments Sales Office/ Distributors for availability and
specifications.
(3) The human body model is a 100 pF capacitor discharged through a 1.5 kΩ resistor into each pin.
Operating Ratings
Supply Voltage
Junction Temperature Range
6.5V to 40V
−40°C ≤ T_J ≤ +125°C
LM2675-3.3 Electrical Characteristics
Specifications with standard type face are for T_J = 25°C, and those with bold type face apply over full Operating
Temperature Range.
Symbol
Parameter
Conditions
Typ ⁽¹⁾
Min ⁽²⁾
Max ⁽²⁾
SYSTEM PARAMETERS Test Circuit Figure 22⁽³⁾
Units
V_OUT
V_OUT
η
Output Voltage
Output Voltage
Efficiency
V_IN = 8V to 40V, I_LOAD = 20 mA to 1A
V_IN = 6.5V to 40V, I_LOAD = 20 mA to 500 mA
V_IN = 12V, I_LOAD = 1A
3.3
3.251/3.201 3.350/3.399 V
3.3
3.251/3.201 3.350/3.399 V
86
%
(1) Typical numbers are at 25°C and represent the most likely norm.
(2) All limits specified at room temperature (standard type face) and at temperature extremes (bold type face). All room temperature limits
are 100% production tested. All limits at temperature extremes are specified via correlation using standard Statistical Quality Control
(SQC) methods. All limits are used to calculate Average Outgoing Quality Level (AOQL).
(3) External components such as the catch diode, inductor, input and output capacitors, and voltage programming resistors can affect
switching regulator performance. When the LM2675 is used as shown in Figure 22 and Figure 23 test circuits, system performance will
be as specified by the system parameters section of the Electrical Characteristics.
Copyright © 2004–2005, Texas Instruments Incorporated
Product Folder Links: LM2675
Submit Documentation Feedback
3