DLPA200 Datasheet, PDF (3/20 Pages) Texas Instruments – DLP® DLPA200 DMD Micromirror Driver

www.ti.com
Device Marking
The device marking consists of the fields shown in Figure 1.
DLPA200
DLPS015A – APRIL 2010 – REVISED JUNE 2010
Figure 1. Device Marking (Device Top View)
TERMINAL
NAME
NO.
OUT00
22
OUT01
24
OUT02
27
OUT03
29
OUT04
32
OUT05
34
OUT06
37
OUT07
39
OUT08
62
OUT09
64
OUT10
67
OUT11
69
OUT12
72
OUT13
74
OUT14
77
OUT15
79
A0
19
A1
18
A2
17
A3
16
MODE0
3
MODE1
2
SEL0
5
SEL1
4
STROBE
15
OE
6
RESET
59
SCPEN
58
TERMINAL FUNCTIONS
I/O
(INPUT
DEFAULT)
DESCRIPTION
Output
16 micromirror clocking waveform outputs (enabled by OE = 0).
Output
Output
Output
Output
Output
Output
Output
Output
Output
Output
Output
Output
Output
Output
Output
Input (pull down) Output Address. Used to select which OUTxx pin is active at a given time.
Input (pull down)
Input (pull down)
Input (pull down)
Input (pull down) Mode Select. Used to determine the operating mode of the DLPA200.
Input (pull down)
Input (pull down) Output Voltage Select. Used to switch the voltage applied to the addressed OUTxx
Input (pull down) ^pin.
Input (pull down) A rising edge on STROBE latches in the control signals after a tri-state delay.
Input (pull up)
Asynchronous input controls whether the 16 OUTxx pins are active or are in a in
high-impedance state.
OE = 0 : Enabled. OE = 1 : High Z.
Input (pull up) Resets the DLPA200 internal logic. Active low. Asynchronous.
Input (pull up) Enables serial bus data transfers. Active low.
Copyright © 2010, Texas Instruments Incorporated
Product Folder Link(s): DLPA200
Submit Documentation Feedback
3