TS5A2053_09 Datasheet, PDF (2/26 Pages) Texas Instruments – SINGLE-CHANNEL 10-R SPDT ANALOG SWITCH WITH ENABLE

TS5A2053
SINGLEĆCHANNEL 10ĆW SPDT ANALOG SWITCH
WITH ENABLE
SCDS183A – JANUARY 2005 – REVISED APRIL 2006
www.ti.com
ORDERING INFORMATION
TA
−40°C to 85°C
PACKAGE(1)
NanoStar − WCSP (DSBGA)
0.23-mm Large Bump − YEP
NanoFree − WCSP (DSBGA)
0.23-mm Large Bump − YZP (Pb-free)
Tape and reel
ORDERABLE PART NUMBER TOP-SIDE MARKING(2)
TS5A2053YEPR
TS5A2053YZPR
SSOP − DCT
Tape and reel
TS5A2053DCTR
JAF_ _ _
VSSOP − DCU
Tape and reel
TS5A2053DCUR
JAF_
(1) _{Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines are available at www.ti.com/sc/package.}
(2) _{DCT: The actual top-side marking has three additional characters that designate the year, month, and assembly/test site.}
DCU: The actual top-side marking has one additional character that designates the assembly/test site.
YEP/YZP: The actual top-side marking has three preceding characters to denote year, month, and sequence code, and one following character
to designate the assembly/test site. Pin 1 identifier indicates solder-bump composition (1 = SnPb, • = Pb-free).
Absolute Minimum and Maximum Ratings(1)(2)
over operating free-air temperature range (unless otherwise noted)
V+
VNO
VNC
VCOM
IK
Supply voltage range(3)
Analog voltage range(3)(4)(5)
Analog port diode current
MIN
−0.5
MAX UNIT
6.5 V
−0.5 V+ + 0.5 V
VNC, VNO, VCOM < 0 or VNO, VNC, VCOM > V+ −50
50 mA
INO
INC
ICOM
VI
On-state switch current
Digital input voltage range(3)(4)
VNC, VNO, VCOM = 0 to V+
−50
−0.5
50 mA
6.5 V
IIK
Digital input clamp current
I+
Continuous current through V+
VI < 0
−50
mA
100 mA
IGND Continuous current through GND
DCT package
−100
mA
220
θ_JA
Package thermal impedance(6)
DCU package
YEP/YZP package
227 °C/W
102
Tstg Storage temperature range
−65
150 °C
(1) _{Stresses above these ratings may cause permanent damage. Exposure to absolute maximum conditions for extended periods may degrade}
device reliability. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those specified
is not implied.
(2) _{The algebraic convention, whereby the most negative value is a minimum and the most positive value is a maximum}
(3) _{All voltages are with respect to ground, unless otherwise specified.}
(4) _{The input and output voltage ratings may be exceeded if the input and output clamp-current ratings are observed.}
(5) _{This value is limited to 5.5 V maximum.}
(6) _{The package thermal impedance is calculated in accordance with JESD 51-7.}
2