THS9001_15 Datasheet, PDF (2/23 Pages) Texas Instruments – 50 MHz to 750 MHz CASCADEABLE AMPLIFIER

THS9001
SLOS426C – NOVEMBER 2003 – REVISED DECEMBER 2013
www.ti.com
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage to the MOS gates.
PACKAGED DEVICE⁽¹⁾
THS9001DBVT
THS9001DBVR
AVAILABLE OPTIONS
PACKAGE TYPE
TRANSPORT MEDIA, QUANTITY
SOT-23-6
Tape and Reel, 250
Tape and Reel, 3000
(1) For the most current package and ordering information, see the Package Option Addendum at the end
of this document, or see the TI Web site at www.ti.com.
ABSOLUTE MAXIMUM RATINGS
Over operating free-air temperature (unless otherwise noted)⁽¹⁾
V_SS Supply voltage, GND to V_S
V_I Input voltage
Continuous power dissipation
T_J Maximum junction temperature
T_J Maximum junction temperature, continuous operation, long term reliability ⁽²⁾
T_stg Storage temperature
ESD Ratings
HBM
:
CDM
MM
UNIT
5.5
GND to V_S
See Dissipation Rating
table
150°C
125°C
–65 to 150°C
2000
1500
100
(1) The absolute maximum ratings under any condition is limited by the constraints of the silicon process. Stresses above these ratings may
cause permanent damage. Exposure to absolute maximum conditions for extended periods may degrade device reliability. These are
stress ratings only, and functional operation of the device at these or any other conditions beyond those specified is not implied.
(2) The maximum junction temperature for continuous operation is limited by package constraints. Operation above this temperature may
result in reduced reliability and/or lifetime of the device.
DISSIPATION RATING TABLE
PACKAGE
DBV ⁽²⁾
θ_JC
(°C/W)
70.1
θ_JA
(°C/W)
215
POWER RATING⁽¹⁾
T_A ≤ 25°C
463 W
T_A = 85°C
185 mW
(1) Power rating is determined with a junction temperature of 125°C. Thermal management of the final PCB should strive to keep the
junction temperature at or below 125°C for best performance.
(2) This data was taken using the JEDEC standard High-K test PCB.
RECOMMENDED OPERATING CONDITIONS
V_SS Supply voltage
T_A Operating free-air temperature,
I_S Supply current
MIN
NOM
MAX UNIT
2.7
5
V
–40
85
°C
100
mA
2
Submit Documentation Feedback
Product Folder Links: THS9001
Copyright © 2003–2013, Texas Instruments Incorporated