TCA6416 Datasheet, PDF (2/31 Pages) Texas Instruments – LOW-VOLTAGE 16-BIT I2C AND SMBus I/O EXPANDER WITH INTERRUPT OUTPUT, RESET, AND CONFIGURATION REGISTERS

TCA6416
LOW-VOLTAGE 16-BIT I²C AND SMBus I/O EXPANDER
WITH INTERRUPT OUTPUT, RESET, AND CONFIGURATION REGISTERS
SCPS153 – DECEMBER 2007
www.ti.com
DESCRIPTION/ORDERING INFORMATION (CONTINUED)
T_A
–40°C to 85°C
ORDERING INFORMATION
PACKAGE ^{(1) (2)}
ORDERABLE PART NUMBER
BGA – ZQS (Pb-free) Reel of 1000
TCA6416ZQSR
QFN – RTW
Reel of 3000
TCA6416RTWR
TSSOP – PW
Tube of 70
Reel of 2000
TCA6416PW
TCA6416PWR
TOP-SIDE MARKING
PH416
PREVIEW
PH416
(1) Package drawings, thermal data, and symbolization are available at www.ti.com/packaging.
(2) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI
website at www.ti.com.
ABC
The bidirectional voltage level translation in the TCA6416 is provided through V_CCI. V_CCI should be connected to
the V_CC of the external SCL/SDA lines. This indicates the V_CC level of the I²C bus to the TCA6416. The voltage
level on the P-port of the TCA6416 is determined by the V_CCP.
The TCA6416 consists of two 8-bit Configuration (input or output selection), Input, Output, and Polarity Inversion
(active high) registers. At power on, the I/Os are configured as inputs. However, the system master can enable
the I/Os as either inputs or outputs by writing to the I/O configuration bits. The data for each input or output is
kept in the corresponding input or output register. The polarity of the Input Port register can be inverted with the
Polarity Inversion register. All registers can be read by the system master.
The system master can reset the TCA6416 in the event of a timeout or other improper operation by asserting a
low in the RESET input. The power-on reset puts the registers in their default state and initializes the I²C/SMBus
state machine. The RESET pin causes the same reset/initialization to occur without depowering the part.
The TCA6416 open-drain interrupt (INT) output is activated when any input state differs from its corresponding
Input Port register state and is used to indicate to the system master that an input state has changed.
INT can be connected to the interrupt input of a microcontroller. By sending an interrupt signal on this line, the
remote I/O can inform the microcontroller if there is incoming data on its ports without having to communicate via
the I²C bus. Thus, the TCA6416 can remain a simple slave device.
The device P-port outputs have high-current sink capabilities for directly driving LEDs while consuming low
device current.
One hardware pin (ADDR) can be used to program and vary the fixed I²C address and allow up to two devices to
share the same I²C bus or SMBus.
ZQS Package Terminal Assignments
E
P13
D P15
C P16
B ADDR
A SCL
5
P11
P14
P17
V_CCP
SDA
4
P10
P12
P01
V_CCI
INT
3
GND
P06
P07
P05
P04
P03
NB
P02
RESET
P00
2
1
2
Submit Documentation Feedback
Product Folder Link(s): TCA6416
Copyright © 2007, Texas Instruments Incorporated