SN74CB3Q3257 Datasheet, PDF (2/13 Pages) Texas Instruments – 4 BIT 1 OF 2 FET MULTIPLEXER/ DEMULTIPLEXER

SN74CB3Q3257
4ĆBIT 1ĆOFĆ2 FET MULTIPLEXER/DEMULTIPLEXER
2.5ĆV/3.3ĆV LOWĆVOLTAGE, HIGHĆBANDWIDTH BUS SWITCH
SCDS135A – SEPTEMBER 2003 − REVISED NOVEMBER 2003
description/ordering information (continued)
The SN74CB3Q3257 is a high-bandwidth FET bus switch utilizing a charge pump to elevate the gate voltage
of the pass transistor, providing a low and flat ON-state resistance (r_on). The low and flat ON-state resistance
allows for minimal propagation delay and supports rail-to-rail switching on the data input/output (I/O) ports. The
device also features low data I/O capacitance to minimize capacitive loading and signal distortion on the data
bus. Specifically designed to support high-bandwidth applications, the SN74CB3Q3257 provides an optimized
interface solution ideally suited for broadband communications, networking, and data-intensive computing
systems.
The SN74CB3Q3257 is a 4-bit 1-of-2 high-speed FET multiplexer/demultiplexer with a single output-enable
(OE) input. The select (S) input controls the data path of the multiplexer/demultiplexer. When OE is low, the
multiplexer/demultiplexer is enabled and the A port is connected to the B port, allowing bidirectional data flow
between ports. When OE is high, the multiplexer/demultiplexer is disabled and a high-impedance state exists
between the A and B ports.
This device is fully specified for partial-power-down applications using I_off. The I_off circuitry prevents damaging
current backflow through the device when it is powered-down. The device has isolation during power off.
To ensure the high-impedance state during power up or power down, OE should be tied to V_CC through a pullup
resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
INPUTS
OE
S
L
L
L
H
H
X
FUNCTION TABLE
INPUT/OUTPUT
A
FUNCTION
B1
A port = B1 port
B2
A port = B2 port
Z
Disconnect
2
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265