|
SN74AUC1GU04 Datasheet, PDF (2/12 Pages) Texas Instruments – SINGLE INVERTER GATE | |||
|
◁ |
SN74AUC1GU04
SINGLE INVERTER GATE
SCES371H â SEPTEMBER 2001 â REVISED FEBRUARY 2004
logic diagram (positive logic)
2
A
4
Y
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)â
Supply voltage range, VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . â0.5 V to 3.6 V
Input voltage range, VI (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . â0.5 V to 3.6 V
Output voltage range, VO (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . â0.5 V to VCC + 0.5 V
Input clamp current, IIK (VI < 0) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . â50 mA
Output clamp current, IOK (VO < 0) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . â50 mA
Continuous output current, IO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±20 mA
Continuous current through VCC or GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±100 mA
Package thermal impedance, θJA (see Note 2): DBV package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 206°C/W
DCK package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 252°C/W
YEA/YZA package . . . . . . . . . . . . . . . . . . . . . . . . . . . 154°C/W
Storage temperature range, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . â65°C to 150°C
â Stresses beyond those listed under âabsolute maximum ratingsâ may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under ârecommended operating conditionsâ is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. The input negative-voltage and output voltage ratings may be exceeded if the input and output current ratings are observed.
2. The package thermal impedance is calculated in accordance with JESD 51-7.
recommended operating conditions (see Note 3)
MIN
MAX
UNIT
VCC
VIH
VIL
VI
VO
Supply voltage
High-level input voltage
Low-level input voltage
Input voltage
Output voltage
IOH High-level output current
IOL
Low-level output current
ât/âv Input transition rise or fall rate
IO = â100 mA
IO = 100 mA
VCC = 0.8 V
VCC = 1.1 V
VCC = 1.4 V
VCC = 1.65 V
VCC = 2.3 V
VCC = 0.8 V
VCC = 1.1 V
VCC = 1.4 V
VCC = 1.65 V
VCC = 2.3 V
0.8
2.7
0.65 Ã VCC
0
0.35 Ã VCC
3.6
0
VCC
â0.7
â3
â5
â8
â9
0.7
3
5
8
9
20
V
V
V
V
V
mA
mA
ns/V
TA
Operating free-air temperature
â40
85
°C
NOTE 3: All unused inputs of the device must be held at VCC or GND to ensure proper device operation. Refer to the TI application report,
Implications of Slow or Floating CMOS Inputs, literature number SCBA004.
2
⢠POST OFFICE BOX 655303 DALLAS, TEXAS 75265
|
▷ |