SN65HVD1176_08 Datasheet, PDF (2/19 Pages) Texas Instruments – PROFIBUS RS-485 TRANSCEIVERS

SN65HVD1176
SN75HVD1176
SLLS563D – JULY 2003 – REVISED DECEMBER 2007
www.ti.com
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage to the MOS gates.
T_A
0C to 70C
-40°C to 85°C
AVAILABLE OPTIONS
PACKAGED DEVICES⁽¹⁾
SN75HVD1176D
SN65HVD1176D
PACKAGE MARKING⁽²⁾
VN1176
VP1176
(1) The D package is available taped and reeled. Add an R suffix to the device type (for example, SN65HVD1176DR).
(2) For the most current package and ordering information, see the Package Option Addendum located at the end of this datasheet or see
the TI website at www.ti.com.
ABSOLUTE MAXIMUM RATINGS
over operating junction temperature range unless otherwise noted⁽¹⁾
V_CC
Supply voltage⁽²⁾
Voltage at any bus I/O terminal
Voltage input, transient pulse, A and B, (through 100 Ω, see Figure 15)
Voltage input at any D, DE or RE terminal
I_O
Receiver output current
Electrostatic discharge
Human Body Model,
(HBM) ⁽³⁾
All pins
Bus terminals and
GND
T_J
Junction temperature
SN65HVD1176
SN75HVD1176
–0.5 to 7
–9 to 14
–40 to 40
–0.5 to 7
–10 to 10
4
10
150
UNIT
V
V
V
V
mA
kV
kV
°C
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under recommended operating
conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability. All voltage
values are with respect to the network ground terminal unless otherwise noted.
(2) All voltage values, except differential I/O bus voltages, are with respect to network ground terminal..
(3) Tested in accordance with JEDEC standard 22. test method A114-A..
RECOMMENDED OPERATING CONDITIONS
V_CC
Supply voltage
Voltage at either bus I/O terminal
V_IH
High-level input voltage
V_IL
Low-level input voltage
V_IL
Differential input voltage
I_O
Output current
T_J
R_L
1/t_U1
Junction temperature ⁽¹⁾
Differential load resistance
Signaling rate
A, B
D, DE, RE
A with respect to B
Driver
Receiver
SN65HVD1176
SN75HVD1176
(1) See the Thermal Characteristics table for more information on maintenance of this requirement.
MIN TYP MAX UNIT
4.75
5 5.25
V
–7
12
V
2
V_CC
V
0
0.8
V
-12
12
V
-70
70 mA
-8
8 mA
-40
130
Ω
0
130
Ω
54
Ω
40 Mbps
2
Submit Documentation Feedback
Copyright © 2003–2007, Texas Instruments Incorporated
Product Folder Link(s): SN65HVD1176 SN75HVD1176