RI-TRP-RR2B_12 Datasheet, PDF (2/4 Pages) Texas Instruments – 32 mm Glass Transponder

RI-TRP-RR2B, RI-TRP-WR2B, RI-TRP-DR2B, RI-TRP-IR2B
32 mm Glass Transponder
SCBS842A – SEPTEMBER 2001 – REVISED FEBRUARY 2008
www.ti.com
OPERATING CHARACTERISTICS
over operating free-air temperature range (unless otherwise noted)
PARAMETER
RI-TRP-RR2B
PART NUMBER
RI-TRP-WR2B
RI-TRP-DR2B
RI-TRP-IR2B
Functionality
Memory (Bits)
Memory (Pages)
Read Only
64
1
Read/Write
80 ⁽¹⁾
1
MPT
1360 ⁽¹⁾
17 ⁽¹⁾R/W
SAMPT
1360 ⁽¹⁾
17⁽¹⁾R/W ⁽²⁾
Operating Frequency
134.2
Modulation
FSK (Frequency Shift Keying) 134.2 kHz / 123.2 kHz
Transmission Principle
HDX (Half Duplex)
Power Source
Typical Read Range
Powered from the reader signal (batteryless)
≤ 100⁽³⁾
Typical Programming Range —
30% of specified reading range
Typical Read Time
70
70
86
86
Typical Programming Time —
309
293
341
Typical Programming Cycles —
100,000
100,000
100,000
Case Material
Glass
Protection Class
Hermetically sealed
EMC
Programmed code is not affected by normal electromagnetic interference or x-rays
Signal Penetration
Transponder can be read through virtually all non-metallic material
Mechanical Shock
IEC 68-2-27, Test Ea; 300 g, half sine, 3 ms, 2 axes
Vibration
Dimensions
IEC 68-2-6, Test Fc; 3 g, 5 – 50 Hz, 2 axes, 24 hours per axis
20 g, 10 – 2000 Hz, 2 axes, 2.5 hours per axis
Φ3.85 ± 0.05⁽¹⁾ 31.2 ± 0.6
Φ3.85 ± 0.05⁽¹⁾ 32.2 ± 0.6
Weight
0.8
0.85
UNIT
kHz
cm
ms
ms
mm
g
(1) We recommend that you split each 80 bit page into 64 user programmable bits plus a 16 bit wide CRC CCITT Block Check Character as
is done by TI-RFID™ LF readers.
(2) 24 bits Selective Address width
(3) Depending on RF regulation in country of use, the Reader Antenna configuration used, and the environmental conditions.
2
Submit Documentation Feedback
Copyright © 2001–2008, Texas Instruments Incorporated
Product Folder Link(s): RI-TRP-RR2B RI-TRP-WR2B RI-TRP-DR2B RI-TRP-IR2B