RI-TRP-R9TD_09 Datasheet, PDF (2/4 Pages) Texas Instruments – 120mm CYLINDRICAL TRANSPONDER

RI-TRP-R9TD, RI-TRP-W9TD, RI-TRP-D9TD
SCBS838 – SEPTEMBER 2001
www.ti.com
OPERATING CHARACTERISTICS
over operating free-air temperature range (unless otherwise noted)
PARAMETER
Functionality
Memory (Bits)
Memory (Pages)
Operating Frequency
Modulation
Transmission Principle
Power Source
Typical Reading Range
Typical Programming Range
Typical Reading Time
Typical Programming Time
Typical Programming Cycles
Case Material
Protection Class
EMC
Signal Penetration
Mechanical Shock
Vibration
Dimensions
Weight
PART NUMBER
RI-TRP-R9TD
RI-TRP-W9TD
Read Only
Read/Write
64
80 ⁽¹⁾
1
1
134.2
FSK (Frequency Shift Keying) 134.2 / 123.2
HDX (Half Duplex)
Powered from the reader signal (batteryless)
≤ 200⁽²⁾
—
30% of specified reading range
70
—
309
—
100,000
Reinforced Poly-Ether-Imide (PEI), black
IP 67
Programmed code is not affected by normal electromagnetic interference or
x-rays
Transponder can be read through virtually all non-metallic material
IEC 68-2-27, Test Ea; 200 g, half sine, 3 ms, 2 axes, 6 shocks per axis
IEC 68-2-6, Test Fc; 20 g, 20 - 500 Hz, 2 axes, 10 cycles per axis
Ø 21 mm ± 0.8 mm × 121 mm ± 2 mm
60
UNIT
kHz
kHz
cm
ms
ms
g
(1) We recommend that you split each 80 bit page into 64 user programmable bits plus a 16 bit wide CRC CCITT Block Check Character as
is done by TI-RFID™ LF readers.
(2) Depending on RF regulation in country of use, the Reader Antenna configuration used, and the environmental conditions.
2
Submit Documentation Feedback