English
Language : 

RI-TRP-R9QL Datasheet, PDF (2/2 Pages) Texas Instruments – 30mm DISK TRANSPONDER
RI-TRP-R9QL, RI-TRP-W9QL
SCBS837 – OCTOBER 2001
ABSOLUTE MAXIMUM RATINGS(1)
over operating free-air temperature range (unless otherwise noted)
www.ti.com
Operating Temperature
Storage Temperature
RI-TRP-R9QL
–25 to +85
–40 to +100
RI-TRP-W9QL
–25 to +70
–40 to +100
UNIT
°C
°C
(1) Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under Recommended Operating
Conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
OPERATING CHARACTERISTICS
over operating free-air temperature range (unless otherwise noted)
PARAMETER
Functionality
Memory (Bits)
Memory (Pages)
Operating Frequency
Modulation
Transmission Principle
Power Source
Typical Reading Range
Typical Programming Range
Typical Reading Time
Typical Programming Time
Typical Programming Cycles @ 25°C
Case Material
Protection Class
EMC
Signal Penetration
Mechanical Shock
Vibration
Dimensions
Weight
PART NUMBER
RI-TRP-R9QL
RI-TRP-W9QL
Read Only
Read/Write
64
80 (1)
1
1
134.2
FSK (Frequency Shift Keying) 134.2 kHz / 123.2 kHz
HDX (Half Duplex)
Powered from the reader signal (batteryless)
≤ 60(2)
—
30% of specified reading range
70
—
309
—
100,000
Poly-Oxy-Methylen (POM), black
IP 67
Programmed code is not affected by normal electromagnetic interference or
x-rays
Transponder can be read through virtually all non-metallic material
IEC 68-2-27, Test Ea; 1500 g, 1 ms, half sine, 3 axes, 6 shocks per axis
IEC 68-2-6, Test Fc; 25 g, 10 - 2000 Hz, 3 axes, 10 cycles per axis
29.4 mm ± 0.5 mm × 8.4 mm ± 0.4 mm
8
UNIT
kHz
cm
ms
ms
g
(1) We recommend that you split each 80 bit page into 64 user programmable bits plus a 16 bit wide CRC CCITT Block Check Character as
is done by TI-RFid™ LF readers.
(2) Depending on RF regulation in country of use, the Reader Antenna configuration used, and the environmental conditions.
2
Submit Documentation Feedback