RI-I17-114A-01_11 Datasheet, PDF (2/5 Pages) Texas Instruments – Tag-it™ HF-I STANDARD TRANSPONDER INLAYS CD

RI-I17-114A-01
SCBS819B – DECEMBER 2005 – REVISED SEPTEMBER 2011
www.ti.com
Table 1. Specifications⁽¹⁾
Supported standard
Recommended operating frequency
Passive resonance frequency (at 25°C)
Typical required activation field strength to read (at 25°C)
Typical required activation field strength to write (at 25°C)
Factory-programmed read-only number
Memory (user programmable)
Typical programming cycles (at 25°C)
Data retention time (at 55°C)
Simultaneous identification of tags
PART NUMBER
RI-I17-114A-01
ISO/IEC 15693-2, -3; ISO/IEC 18000-3
13.56 MHz
13.80 MHz ± 400 kHz (includes frequency offset to compensate further
integration into paper or PVC lamination)
110 dBμA/m⁽²⁾
113 dBμA/m⁽²⁾
64 bits
256 bits organized in 8-bit × 32-bit blocks
100,000
>10 years
Up to 50 tags per second (reader/antenna dependent)
Antenna size
Foil width
Foil pitch
Thickness
Outer diameter: ø 32.5 mm +0.1 mm/–0.2 mm (~1.28 in)
Inner diameter: min. ø 18 mm (~0.7 in)
48 mm ± 0.5 mm (1.89 in ± 0.02 in)
50.8 mm +0.1 mm/–0.4 mm (2 in)
Chip area: 0.34 mm ±0.02
Antenna area (Al both sides): 0.085 mm ±0.01
Antenna area (Al one side): 0.075 mm ±0.008
Base material
Operating temperature
Storage temperature (single inlay)
Storage temperature (on reel)
Substrate: PET (polyethylenetherephtalate)
Antenna: Aluminum
–25°C to 70°C
–40°C to 85°C (warpage may occur at upper temperature range)
–40°C to 40°C
Deliver
Typical quantity of good units per reel
Single-row tape wound on cardboard reel with 500-mm diameter
Reel outer width: approximately 60 mm (~2.36 in)
Reel inner width: approximately 50 mm (~1.97 in)
Hub diameter: 76.2 mm (3 in)
5,000
(1) For highest possible read-out coverage, operate readers at a modulation depth of 20% or higher.
(2) After integration into paper or PVC lamination.
Table 2. Supported Command Set
REQUEST
REQUEST
CODE
REQUEST MODE⁽¹⁾
INVENTORY
ADDRESSED NON-ADDRESSED
AFI
ISO 15693 Mandatory and Optional Commands
Inventory
0x01
✓
–
–
✓
Stay Quiet
0x02
–
✓
–
–
Read_Single_Block
0x20
–
✓
✓
–
Write_Single_Block
0x21
–
✓
✓
–
Lock_Block
0x22
–
✓
✓
–
(1) ✓ = Implemented, – = Not applicable
OPTIONAL
FLAG
0
0
1
1
1
2
Submit Documentation Feedback
Copyright © 2005–2011, Texas Instruments Incorporated
Product Folder Link(s): RI-I17-114A-01