RI-I16-112A-03_10 Datasheet, PDF (2/4 Pages) Texas Instruments – Tag-it™ HF-I PLUS TRANSPONDER INLAYS 24.2-mm CIRCULAR

RI-I16-112A-03
SCBS826A – OCTOBER 2004 – REVISED APRIL 2010
www.ti.com
Table 1. SPECIFICATIONS⁽¹⁾
Supported standard
Recommended operating frequency
Passive resonance frequency (at 25°C)
Typical required activation field strength to read (at 25°C)
Typical required activation field strength to write (at 25°C)
Factory programmed read-only number
Memory (user programmable)
Typical programming cycles (at 25°C)
Data retention time (at 55°C)
Simultaneous identification of tags
Antenna size
Foil width
Foil pitch
Thickness
Base material
Smallest bending radius allowed
Operating temperature
Storage temperature (single inlay)
Storage temperature (on reel)
Delivery
Typical quantity of good units per reel
PART NUMBER
RI-I16-112A-03
ISO/IEC 15693-2, -3; ISO/IEC 18000-3
13.56 MHz
13.70 MHz ± 400 kHz (includes frequency offset to compensate further
integration into paper or PVC lamination)
113 dBmA/m⁽²⁾
116 dBmA/m⁽²⁾
64 bits
2k bits organized in 64-bit × 32-bit blocks
100,000
>10 years
Up to 50 tags per second (reader/antenna dependent)
ø 24.2 mm +0.1 mm/–0.2 mm (~1.95 in)
48 mm ± 0.5 mm (1.89 in ± 0.02 in)
50.8 mm +0.1 mm/–0.4 mm (2 in)
Chip area: 0.34 mm ±0.02
Antenna area (Al both sides): 0.085 mm ±0.01
Antenna area (Al one side): 0.075 mm ±0.008
Substrate: PET (polyethylenetherephtalate); Antenna: aluminum
18 mm (~0.71 in)
–25°C to 70°C
–40°C to 85°C (warpage may occur at upper temperature range)
–40°C to 40°C
Single-row tape wound on cardboard reel with 500-mm diameter
Reel outer width: approximately 60 mm (~2.36 in)
Reel inner width: approximately 50 mm (~1.97 in)
Hub diameter: 76.2 mm (3 in)
5,000
(1) For highest possible read-out coverage, operate readers at a modulation depth of 20% or higher.
(2) After integration into paper
2
Submit Documentation Feedback
Copyright © 2004–2010, Texas Instruments Incorporated
Product Folder Link(s): RI-I16-112A-03