OPA378_1 Datasheet, PDF (2/24 Pages) Texas Instruments – Low-Noise, 900kHz, RRIO, Precision OPERATIONAL AMPLIFIER Zerø-Drift Series

OPA378
OPA2378
SBOS417C – JANUARY 2008 – REVISED JUNE 2009 ..................................................................................................................................................... www.ti.com
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.
PACKAGE INFORMATION⁽¹⁾
PRODUCT
OPA378
OPA378
OPA2378 ⁽²⁾
PACKAGE-LEAD
SOT23-5
SC70-5
SOT23-8
PACKAGE DESIGNATOR
DBV
DCK
DCN
PACKAGE MARKING
OAZI
BTS
OCAI
(1) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI
web site at www.ti.com.
(2) Available 3Q 2009.
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Over operating free-air temperature range (unless otherwise noted).
Supply Voltage, V_S = (V+) – (V–)
Signal Input Terminals
Output Short-Circuit⁽³⁾
Operating Temperature, T_A
Storage Temperature, T_A
Junction Temperature, T_J
ESD Ratings
Voltage ⁽²⁾
Current ⁽²⁾
Human Body Model (HBM)
Charged Device Model (CDM)
Machine Model (MM)
OPA378, OPA2378
+7
(V–) – 0.3 ≤ V_IN ≤ (V+) + 0.3
±10
Continuous
–55 to +150
–65 to +150
+150
4000
1000
200
UNIT
V
V
mA
°C
°C
°C
V
V
V
(1) Stresses above these ratings may cause permanent damage. Exposure to absolute maximum conditions for extended periods may
degrade device reliability. These are stress ratings only, and functional operation of the device at these or any other conditions beyond
those specified is not supported.
(2) Input terminals are diode-clamped to the power-supply rails. Input signals that can swing more than 0.3V beyond the supply rails should
be current limited to 10mA or less.
(3) Short-circuit to ground, one amplifier per package.
PIN CONFIGURATIONS
OPA378
SC70-5
(TOP VIEW)
+In 1
V- 2
-In 3
5 V+
4 Out
OPA378
SOT23-5
(TOP VIEW)
Out 1
V- 2
+In 3
5 V+
4 -In
OPA2378
SOT23-8
(TOP VIEW)
Out A 1
-In A 2
+In A 3
V- 4
A
B
8 V+
7 Out B
6 -In B
5 +In B
NOTE: The OPA2378 will be available 3Q 2009.
2
Submit Documentation Feedback
Copyright © 2008–2009, Texas Instruments Incorporated
Product Folder Link(s): OPA378 OPA2378