OPA365-Q1_15 Datasheet, PDF (2/26 Pages) Texas Instruments – 50-MHz Low-Distortion High-CMRR Rail-to-Rail I/O, Single-Supply Operational Amplifier

OPA365-Q1
OPA2365-Q1
SBOS512C – MARCH 2010 – REVISED APRIL 2012
www.ti.com
R₂
2kΩ
C₂
2.2pF
V−
U1
OPA365
V_IN
V+
SD1
BAT1 7
V−
U2
OPA365
R₁
7.5Ω
V+
C₁
10nF
V_OUT
Figure 1. Fast-Settling Peak Detector
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.
T_A
–40°C to 125°C
Single
Dual
ORDERING INFORMATION⁽¹⁾
PACKAGE ⁽²⁾
ORDERABLE PART NUMBER
SOT23 – DBV Reel of 2500 OPA365AQDBVRQ1
SOIC – D
Reel of 2500 OPA2365AQDRQ1
TOP-SIDE MARKING
OTNQ
O2365Q
(1) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI
web site at www.ti.com.
(2) Package drawings, thermal data, and symbolization are available at www.ti.com/packaging.
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
V_CC Supply voltage
V_I
Signal input terminals, voltage⁽²⁾
I_I
Signal input terminals, current⁽²⁾
t_OSC Output short-circuit duration⁽³⁾
T_OP Operating temperature
T_stg Storage temperature
T_J
Junction temperature
ESD Electrostatic discharge rating
Human Body Model (HBM) AEC-Q100
Classification Level H2
Charged Device Model (CDM) AEC-Q100
Classification Level C3B
+5.5 V
(V−) − 0.5V to (V+) + 0.5 V
±10 mA
Continuous
−40°C to 150°C
–65°C to 150°C
150°C
2 kV
750 V
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under recommended operating
conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) Input terminals are diode-clamped to the power-supply rails. Input signals that can swing more than 0.5V beyond the supply rails should
be current limited to 10mA or less.
(3) Short-circuit to ground, one amplifier per package
2
Submit Documentation Feedback
Copyright © 2010–2012, Texas Instruments Incorporated
Product Folder Link(s): OPA365-Q1