OPA362 Datasheet, PDF (2/18 Pages) Texas Instruments – 3V VIDEO AMPLIFIER with Internal Gain and Filter in SC70

OPA362
SBOS480 – SEPTEMBER 2009 ........................................................................................................................................................................................ www.ti.com
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Over operating free-air temperature range, unless otherwise noted.
Supply Voltage, V+ to V–
Signal Input
Terminals
Voltage ⁽²⁾
Current ⁽²⁾
Output Short-Circuit through 75Ω to GND⁽³⁾
Operating Temperature
Storage Temperature
Junction Temperature
Human Body Model (HBM)
ESD Ratings
Charged Device Model (CDM)
Machine Model (MM)
VALUE
+3.6
– 0.5 to (V+) + 0.5
±10
Continuous
–40 to +125
–65 to +150
+160
5000
2000
400
UNIT
V
V
mA
°C
°C
°C
V
V
V
(1) Stresses above these ratings may cause permanent damage. Exposure to absolute maximum conditions for extended periods may
degrade device reliability. These are stress ratings only, and functional operation of the device at these or any other conditions beyond
those specified is not supported.
(2) Input terminals are diode-clamped to the power-supply rails. Input signals that can swing more than 0.5V beyond the supply rails should
be current-limited to 10mA or less.
(3) Short-circuit to ground.
PRODUCT
OPA362
PACKAGE INFORMATION⁽¹⁾
PACKAGE-LEAD
PACKAGE DESIGNATOR
SC70-6
DCK
PACKAGE MARKING
OEA
(1) For the most current package and ordering information see the Package Option Addendum at the end of this document, or see the TI
web site at www.ti.com.
DCK PACKAGE
SC70-6
(TOP VIEW)
+In 1
GND 2
R_{SET 3}
6 V+
5 Enable
4 Out
Note: The location of pin 1 on the OPA362 is determined by orienting the package marking as shown in the illustration.
2
Submit Documentation Feedback
Product Folder Link(s): OPA362
Copyright © 2009, Texas Instruments Incorporated