OPA361AIDCKTG4 Datasheet, PDF (2/17 Pages) Texas Instruments – 3V VIDEO AMPLIFIER with Internal Gain and Filter in SC70

OPA361
SBOS334A − SEPTEMBER 2005 − REVISED JANUARY 2006
www.ti.com
ORDERING INFORMATION⁽¹⁾
PRODUCT
PACKAGE
PACKAGE DESIGNATOR
PACKAGE MARKING
OPA361
SC70-6
DCK
AUY
(1) _{For the most current package and ordering information, see the Package Option Addendum at the end of this datasheet, or see the TI website}
at www.ti.com.
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with appropriate
precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more susceptible to
damage because very small parametric changes could cause the device not to meet its published specifications.
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Supply Voltage, V+ to V− . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +3.6V
Signal Input Terminals, Voltage(2) . . . . . . . . −0.5V to (V+) + 0.5V
Current(2) . . . . . . . . . . . . . . . . . . . ±10mA
Output Short-Circuit through 75Ω to GND(3) . . . . . . . Continuous
Operating Temperature . . . . . . . . . . . . . . . . . . . . . −40°C to +125°C
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . −65°C to +150°C
Junction Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +160°C
ESD Rating:
Human Body Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5000V
Machine Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 400V
Charged Device Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2000V
(1) _{Stresses above these ratings may cause permanent damage.}
Exposure to absolute maximum conditions for extended periods
may degrade device reliability. These are stress ratings only, and
functional operation of the device at these or any other conditions
beyond those specified is not implied.
(2) _{Input terminals are diode-clamped to the power-supply rails.}
Input signals that can swing more than 0.5V beyond the supply
rails should be current-limited to 10mA or less.
(3) _{Short-circuit to ground.}
PIN CONFIGURATION
Top View
SC70
+In 1
GND 2
R_SET 3
6 V+
5 Enable
4 Out
NOTE: The location of pin 1 on the OPA361 is determined by orienting
the package marking as shown in the diagram above.
2