OPA340-EP Datasheet, PDF (2/17 Pages) Texas Instruments – SINGLE-SUPPLY RAIL-TO-RAIL OPERATIONAL AMPLIFIERS

OPA340-EP
OPA2340-EP
OPA4340-EP
SBOS433 – AUGUST 2008 ................................................................................................................................................................................................ www.ti.com
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.
T_A
–55°C to 125°C
Single
Dual
Quad
ORDERING INFORMATION⁽¹⁾
PACKAGE ⁽²⁾
SOIC – D (8 pin)
Reel of 2500
ORDERABLE PART NUMBER
OPA340MDREP ⁽³⁾
SOT23-5 – DBV
SOIC – D (8 pin)
SOIC – D (14 pin)
Reel of 250
Reel of 2500
Reel of 2500
OPA340MDBVTEP
OPA2340MDREP ⁽³⁾
OPA4340MDREP ⁽³⁾
TOP-SIDE MARKING
PREVIEW
CVS
PREVIEW
PREVIEW
(1) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI
web site at www.ti.com.
(2) Package drawings, thermal data, and symbolization are available at www.ti.com/packaging.
(3) Product preview. Contact your TI sales representative for availability.
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
V_S
Supply voltage
V_I
Signal input voltage⁽²⁾
V_O
Signal input current⁽²⁾
Output short-circuit⁽³⁾
T_A
Operating free-air temperature range
T_stg Storage temperature range
T_J
Operating virtual-junction temperature
5.5 V
(V–) – 0.5 V to (V+) + 0.5 V
10 mA
Continuous
–55°C to 125°C
–55°C to 125°C
150°C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) Input terminals are diode-clamped to the power-supply rails. Input signals that can swing more than 0.5 V beyond the supply rails should
be current limited to 10 mA or less.
(3) Short-circuit to ground, one amplifier per package.
2
Submit Documentation Feedback
Copyright © 2008, Texas Instruments Incorporated
Product Folder Link(s): OPA340-EP OPA2340-EP OPA4340-EP