OPA1S2384 Datasheet, PDF (2/23 Pages) Texas Instruments – 250-MHz, CMOS Transimpedance Amplifier (TIA) with Integrated Switch and Buffer

OPA1S2384
OPA1S2385
SBOS645A – DECEMBER 2012 – REVISED JUNE 2013
www.ti.com
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes could cause the device not to meet its published specifications.
PRODUCT
OPA1S2384
OPA1S2385
PACKAGE-LEAD
SON-10
PACKAGE INFORMATION⁽¹⁾
PACKAGE
DESIGNATOR
SPECIFIED
TEMPERATURE
RANGE
DRC
–40°C to +85°C
SON-10
DRC
–40°C to +85°C
PACKAGE
MARKING
OVAQ
OUZQ
ORDERING NUMBER
OPA1S2384IDRCT
OPA1S2384IDRCR
OPA1S2385IDRCT
OPA1S2385IDRCR
(1) For the most current package and ordering information see the Package Option Addendum at the end of this document, or see the
product folder at www.ti.com.
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Over operating free-air temperature range (unless otherwise noted).
Supply voltage, V+ to V–
Signal input terminals, op amp
section
Voltage ⁽²⁾
Current ⁽²⁾
On-state switch current; V_{IN S}, V_{+IN B} = 0 to V+
Output (OUT A, OUT B) short-circuit current⁽³⁾
Digital input voltage range (SC pin)
Digital input clamp current (SC pin)
Operating temperature, T_A
Storage temperature, T_stg
Junction temperature, T_J
Electrostatic discharge (ESD)
ratings
Human body model (HBM)
Charged-device model (CDM)
OPA1S238x
6
(V–) – 0.3 to (V+) + 0.3
±10
±20
Continuous
–0.3 to +6
–50
–40 to +125
–65 to +150
+150
4000
1000
UNIT
V
V
mA
mA
V
mA
°C
°C
°C
V
V
(1) Stresses above these ratings may cause permanent damage. Exposure to absolute maximum conditions for extended periods may
degrade device reliability. These are stress ratings only, and functional operation of the device at these or any other conditions beyond
those specified is not implied.
(2) Input terminals are diode-clamped to the power-supply rails. Input signals that can swing more than 0.5 V beyond the supply rails should
be current limited to 10 mA or less.
(3) Short-circuit to ground, one amplifier per package.
2
Submit Documentation Feedback
Copyright © 2012–2013, Texas Instruments Incorporated
Product Folder Links: OPA1S2384 OPA1S2385