LP3883_15 Datasheet, PDF (2/19 Pages) Texas Instruments – 3A Fast-Response Ultra Low Dropout Linear Regulators

LP3883
SNVS223F – NOVEMBER 2002 – REVISED APRIL 2013
Block Diagram
www.ti.com
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage to the MOS gates.
ABSOLUTE MAXIMUM RATINGS⁽¹⁾⁽²⁾
Storage Temperature Range
Lead Temp. (Soldering, 5 seconds)
ESD Rating
Power Dissipation⁽⁵⁾
Human Body Model⁽³⁾
Machine Model⁽⁴⁾
V_IN Supply Voltage (Survival)
V_BIAS Supply Voltage (Survival)
Shutdown Input Voltage (Survival)
I_OUT (Survival)
Output Voltage (Survival)
Junction Temperature
−65°C to +150°C
260°C
2 kV
200V
Internally Limited
−0.3V to +6V
−0.3V to +7V
−0.3V to +7V
Internally Limited
−0.3V to +6V
−40°C to +150°C
(1) Absolute maximum ratings indicate limits beyond which damage to the component may occur. Operating ratings indicate conditions for
which the device is intended to be functional, but do not ensure specific performance limits. For ensured specifications, see Electrical
Characteristics. Specifications do not apply when operating the device outside of its rated operating conditions.
(2) If Military/Aerospace specified devices are required, please contact the Texas Instruments Sales Office/ Distributors for availability and
specifications.
(3) The human body model is a 100 pF capacitor discharged through a 1.5k resistor into each pin.
(4) The machine model is a 220 pF capacitor discharged directly into each pin. The machine model ESD rating of pin 5 is 100V.
(5) At elevated temperatures, device power dissipation must be derated based on package thermal resistance and heatsink thermal values.
θ_J-A for TO-220 devices is 65°C/W if no heatsink is used. If the TO-220 device is attached to a heatsink, a θ_J-S value of 4°C/W can be
assumed. θ_J-A for DDPAK/TO-263 devices is approximately 40°C/W if soldered down to a copper plane which is at least 1.5 square
inches in area. If power dissipation causes the junction temperature to exceed specified limits, the device will go into thermal shutdown.
OPERATING RATINGS
V_IN Supply Voltage
Shutdown Input Voltage
I_OUT
Operating Junction Temperature Range
V_BIAS Supply Voltage
(V_OUT + V_DO) to 5.5V
0 to +6V
3A
−40°C to +125°C
4.5V to 6V
2
Submit Documentation Feedback
Product Folder Links: LP3883
Copyright © 2002–2013, Texas Instruments Incorporated