PT6510 Datasheet, PDF (18/19 Pages) Texas Instruments – 8-A 5-V/3.3-V Input Adjustable ISR with Short-Circuit protection

MECHANICAL DATA
EEL (R–PSIP–G14)
1.71 (43,43) MAX.
0.38
(9,65)
0.59
(14,98)
0.71
(18,07)
MPSI020 – MARCH 2001
PLASTIC SINGLE-IN-LINE MODULE
0.040 (1,01)
Note J
0.19 (4,82)
0.210 (5,33)
0.042 (1,06)
0.036 (0,91)
0.87
(22,11)
0.52
(13,20)
1
0.205 (5,20)
1.22 (30,98)
MAX.
Note F
0.100 (2,54) TYP.
0.017 (0,43) TYP.
0.080 (2,02) MIN.
0.42
(10,66)
MAX.
Seating Plane
0.006 (0,15) MAX.
0.175 (4,44)
1.77 (44,95)
1.42 (30,06)
Note E
0°–7°
Gage Plane
0.040
(1,01)
0.017(0,43) TYP.
0.10
(2,54)
0.545
(13,84)
CLtoCL
Note L
1.120
(28,44)
1.35
(34,29)
CLtoCL
0.33 ^0.280
(8,38) ^(7,11)
0.080(2,03) 2 Places
Note H
Note K
0.17 (4,32)
0.150 (3,81)
Note G
0.035 (0,88) 14 Places
0.100 (2,54) 13 Places
0.235 (5,97)
PC LAYOUT
NOTES: A. All linear dimensions are in inches (mm).
B. This drawing is subject to change without notice.
C. 2–place decimals are " 0.030 (" 0, 76 mm).
D. 3–place decimals are " 0.010 (" 0, 25 mm).
E. Recommended mechanical keep-out area.
F. The metal tab is isolated but electrically conductive.
No signal traces are allowed under the metal tab area.
A solid copper island is recommended, which may be
grounded.
G. Power pin connections should utilize two or more
vias per input, ground and output pin.
0.085 (2,16)
0.210
(5,33)
0.38
(9,65)
4202012/A 02/01
H. Minimum copper land area required for solder tab.
Vias are recommended to improve copper adhesion
or connect land to other ground area.
J. Underside solder tabs detail
K. Solder mask openings to copper island for solder
joints to mechanical pins.
L. No copper, power or signal traces in this area.
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
1