|
OPA2846 Datasheet, PDF (17/24 Pages) Texas Instruments – Dual, Wideband, Low-Noise, Voltage-Feedback Operational Amplifier | |||
|
◁ |
OPA2846
www.ti.com
AC-COUPLED, SINGLE-TO-DIFFERENTIAL
ADC DRIVER
Where the signal path may be AC-coupled, a very
balanced, high SFDR dual op amp interface circuit can
easily be provided by the OPA2846. Figure 10 shows a
specific example of this application, where the input
single-to-differential conversion is provided by an input
transformer. Once the signal source is purely differential,
the circuit of Figure 10 provides low harmonic distortion
with a common-mode control path that does not interact
with the signal path gain. If the source is already
differential, such as at the output of a balanced mixer, the
input transformer could be replaced by blocking
capacitors.
In the example of Figure 10, the secondary of the
transformer is connected into the two inverting path gain
resistors (100â¦). These resistors provide both an input
impedance match (assuming a 50⦠source on the primary
of this 1:2 step-up transformer) and set the signal gain for
each amplifier along with the 500⦠feedback resistors.
Although relatively high signal gain is provided by this
SBOS274A âJUNE 2003 â REVISED MARCH 2004
circuit (10 in this case), each amplifier is operating at a
relatively low noise gain (3.5V/V). This low-noise gain at
low frequencies gives high loop gain for distortion
suppression in the baseband. External compensation
capacitors (18pF and 2.1pF) are included to hold the
frequency response flat, as described in the Low-Gain
Compensation For Improved SFDR section of this data
sheet. The common-mode operating voltage is fed into
each amplifierâs noninverting input. Since these are equal,
and will appear at each inverting input as well, no DC
current is produced through the transformer secondary
due to this common-mode operating voltage. Since no
current flows due to VCM, the output will operate at VCM as
well. This is one of the few common-mode operating point
control techniques that requires no current to flow. This
makes the common-mode control aspect of this circuit
essentially non-interactive with the signal path. To provide
a 2VPP differential signal operating at a 2.5V output
common-mode requires a 2.0V to 3.0V output swing on
each output. Tested performance over frequency for the
circuit of Figure 10 is shown in Figure 11.
Powerâsupply decoupling
not shown.
VCM
+5V
1000pF
1/2
R1
OPA2846
18pF
2.1pF
VI
50â¦
1:2
100â¦
100â¦
500â¦
500â¦
VCM +10VI
2.1pF
SingleâtoâDifferential
Gain of 10
18pF
1/2
VCM OPA2846
R1
1000pF
â5V
L
500â¦
V+
C
R2
2.5V
1µF
14âBit
10MSPS
ADS850
VCM
500â¦
L
Vâ
C
R2
Figure 10. AC-Coupled, Single-to-Differential High SFDR ADC Driver
17
|
▷ |