LM3S6730 Datasheet, PDF (146/441 Pages) Texas Instruments – Stellaris LM3S6730 Microcontroller

General-Purpose Input/Outputs (GPIOs)
■ GPIO Port B: 0x4000.5000
■ GPIO Port C: 0x4000.6000
■ GPIO Port D: 0x4000.7000
■ GPIO Port E: 0x4002.4000
■ GPIO Port F: 0x4002.5000
■ GPIO Port G: 0x4002.6000
Important: The GPIO registers in this chapter are duplicated in each GPIO block; however,
depending on the block, all eight bits may not be connected to a GPIO pad. In those
cases, writing to those unconnected bits has no effect, and reading those unconnected
bits returns no meaningful data.
Note:
The default reset value for the GPIOAFSEL, GPIOPUR, and GPIODEN registers are
0x0000.0000 for all GPIO pins, with the exception of the five JTAG/SWD pins (PB7 and
PC[3:0]). These five pins default to JTAG/SWD functionality. Because of this, the default
reset value of these registers for GPIO Port B is 0x0000.0080 while the default reset value
for Port C is 0x0000.000F.
The default register type for the GPIOCR register is RO for all GPIO pins with the exception
of the five JTAG/SWD pins (PB7 and PC[3:0]). These five pins are currently the only
GPIOs that are protected by the GPIOCR register. Because of this, the register type for
GPIO Port B7 and GPIO Port C[3:0] is R/W.
The default reset value for the GPIOCR register is 0x0000.00FF for all GPIO pins, with the
exception of the five JTAG/SWD pins (PB7 and PC[3:0]). To ensure that the JTAG port
is not accidentally programmed as a GPIO, these five pins default to non-committable.
Because of this, the default reset value of GPIOCR for GPIO Port B is 0x0000.007F while
the default reset value of GPIOCR for Port C is 0x0000.00F0.
Table 8-3. GPIO Register Map
Offset Name
Type
0x000 GPIODATA
0x400 GPIODIR
0x404 GPIOIS
0x408 GPIOIBE
0x40C GPIOIEV
0x410 GPIOIM
0x414 GPIORIS
0x418 GPIOMIS
0x41C GPIOICR
0x420 GPIOAFSEL
0x500 GPIODR2R
0x504 GPIODR4R
0x508 GPIODR8R
R/W
R/W
R/W
R/W
R/W
R/W
RO
RO
W1C
R/W
R/W
R/W
R/W
Reset
0x0000.0000
0x0000.0000
0x0000.0000
0x0000.0000
0x0000.0000
0x0000.0000
0x0000.0000
0x0000.0000
0x0000.0000
-
0x0000.00FF
0x0000.0000
0x0000.0000
Description
GPIO Data
GPIO Direction
GPIO Interrupt Sense
GPIO Interrupt Both Edges
GPIO Interrupt Event
GPIO Interrupt Mask
GPIO Raw Interrupt Status
GPIO Masked Interrupt Status
GPIO Interrupt Clear
GPIO Alternate Function Select
GPIO 2-mA Drive Select
GPIO 4-mA Drive Select
GPIO 8-mA Drive Select
See
page
148
149
150
151
152
153
154
155
156
157
159
160
161
146
April 04, 2010
Texas Instruments-Production Data