TLC59281 Datasheet, PDF (13/19 Pages) Texas Instruments – 16-Channel, Constant-Current LED Driver

TLC59281
www.ti.com
SBVS139 – JANUARY 2010
DETAILED DESCRIPTION
SETTING FOR THE CONSTANT SINK CURRENT VALUE
The constant-current values are determined by an external resistor (R_IREF) placed between IREF and GND. The
resistor (R_IREF) value is calculated by Equation 1.
R_IREF (kW) =
V_IREF (V)
I_OLC (mA)
´ 42
Where:
V_IREF = the internal reference voltage on the IREF pin (typically 1.20 V)
(1)
I_OLC must be set in the range of 2 mA to 35 mA. The constant sink current characteristic for the external resistor
value is shown in Figure 10. Table 1 describes the constant-current output versus external resistor value.
Table 1. Constant-Current Output versus External Resistor Value
I_OLCMax (mA, Typical)
35
30
25
20
15
10
5
2
R_IREF (kΩ)
1.44
1.68
2.02
2.52
3.36
5.04
10.1
25.2
CONSTANT-CURRENT DRIVER ON/OFF CONTROL
When BLANK is low, the corresponding output is turned on if the data in the on/off control data latch are '1' and
remains off if the data are '0'. When BLANK is high, all outputs are forced off. This control is shown in Table 2.
Table 2. On/Off Control Data Truth Table
ON/OFF CONTROL LATCH DATA
0
1
CONSTANT-CURRENT OUTPUT STATUS
Off
On
When the IC is initially powered on, the data in the on/off control shift register and data latch are not set to the
respective default value. Therefore, the on/off control data must be written to the data latch before turning the
constant-current output on. BLANK should be at a high level when powered on because the constant-current
may be turned on as a result of random data in the on/off control latch.
The on/off data corresponding to any unconnected OUTn outputs should be set to ‘0’ before turning on the
remaining outputs. Otherwise, the supply current (I_CC) increases while the LEDs are on.
Copyright © 2010, Texas Instruments Incorporated
Product Folder Link(s): TLC59281
Submit Documentation Feedback
13