LP2980AIM5-5.0 Datasheet, PDF (12/24 Pages) Texas Instruments – LP2980-N Micropower 50 mA Ultra Low-Dropout Regulator In SOT-23 Package

LP2980-N
SNOS733M – APRIL 2000 – REVISED JUNE 2013
www.ti.com
V_IN
V_OUT
PNP
GND
Figure 37. LP2980 Reverse Current Path
However, if the input voltage is more than a V_BE below the output voltage, this diode will turn ON and current will
flow into the regulator output. In such cases, a parasitic SCR can latch which will allow a high current to flow into
the V_IN pin and out the ground pin, which can damage the part.
The internal diode can also be turned on if the input voltage is abruptly stepped down to a voltage which is a V_BE
below the output voltage.
In any application where the output voltage may be higher than the input voltage, an external Schottky diode
must be connected from V_IN to V_OUT (cathode on V_IN, anode on V_OUT. See Figure 38), to limit the reverse voltage
across the LP2980-N to 0.3V (See ABSOLUTE MAXIMUM RATINGS).
SCHOTTKY DIODE
V_IN
V_OUT
PNP
GND
Figure 38. Adding External Schottky Diode Protection
ON/OFF INPUT OPERATION
The LP2980-N is shut off by pulling the ON/OFF input low, and turned on by driving the input high. If this feature
is not to be used, the ON/OFF input should be tied to V_IN to keep the regulator on at all times (the ON/OFF input
must not be left floating).
To ensure proper operation, the signal source used to drive the ON/OFF input must be able to swing above and
below the specified turn-on/turn-off voltage thresholds which ensure an ON or OFF state (see ELECTRICAL
CHARACTERISTICS).
The ON/OFF signal may come from either a totem-pole output, or an open-collector output with pull-up resistor to
the LP2980-N input voltage or another logic supply. The high-level voltage may exceed the LP2980-N input
voltage, but must remain within the Absolute Maximum Ratings for the ON/OFF pin.
It is also important that the turn-on/turn-off voltage signals applied to the ON/OFF input have a slew rate which is
greater than 40 mV/μs.
IMPORTANT: The regulator shutdown function will not operate correctly if a slow-moving signal is used to drive
the ON/OFF input.
12
Submit Documentation Feedback
Product Folder Links: LP2980-N
Copyright © 2000–2013, Texas Instruments Incorporated