OPA2703EA-2K5G4 Datasheet, PDF (10/19 Pages) Texas Instruments – CMOS, Rail-to-Rail, I/O OPERATIONAL AMPLIFIERS

APPLICATIONS INFORMATION
OPA703 and OPA704 series op amps can operate on 160µA
quiescent current from a single (or split) supply in the range
of 4V to 12V (±2V to ±6V), making them highly versatile
and easy to use. The OPA703 is unity-gain stable and offers
1MHz bandwidth and 0.6V/µs slew rate. The OPA704 is
optimized for gains of 5 or greater with a 3MHz bandwidth
and 3V/µs slew rate.
Rail-to-rail input and output swing helps maintain dynamic
range, especially in low supply applications. Figure 1 shows
the input and output waveforms for the OPA703 in unity-
gain configuration. Operation is from a ±5V supply with a
100kΩ load connected to V_S/2. The input is a 10Vp-p
sinusoid. Output voltage is approximately 10Vp-p.
Input
G = +1, V_S = ±5V
Output (inverted on scope)
200µs/div
FIGURE 1. Rail-to-Rail Input and Output.
Power-supply pins should be bypassed with 1000pF ceramic
capacitors in parallel with 1µF tantalum capacitors.
OPERATING VOLTAGE
OPA703 and OPA704 series op amps are fully specified and
guaranteed from +4V to +12V over a temperature range of
–40ºC to +85ºC. Parameters that vary significantly with
operating voltages or temperature are shown in the Typical
Performance Curves.
RAIL-TO-RAIL INPUT
The input common-mode voltage range of the OPA703 series
extends 300mV beyond the supply rails at room temperature.
This is achieved with a complementary input stage—an N-
channel input differential pair in parallel with a P-channel
differential pair, as shown in Figure 2. The N-channel pair is
active for input voltages close to the positive rail, typically
(V+) – 2.0V to 300mV above the positive supply, while the P-
channel pair is on for inputs from 300mV below the negative
supply to approximately (V+) – 1.5V. There is a small
transition region, typically (V+) – 2.0V to (V+) – 1.5V, in
which both pairs are on. This 500mV transition region can
vary ±100mV with process variation. Thus, the transition
region (both stages on) can range from (V+) – 2.1V to (V+)
– 1.4V on the low end, up to (V+) – 1.9V to (V+) – 1.6V on
the high end. Within the 500mV transition region PSRR,
CMRR, offset voltage, and offset drift, and THD may vary
compared to operation outside this region.
V+
V_IN+
V_IN–
V–
FIGURE 2. Simplified Schematic.
10
V_O
OPA703, OPA704
SBOS180A