UCC28700_15 Datasheet, PDF (1/35 Pages) Texas Instruments – UCC2870x Constant-Voltage, Constant-Current Controller With Primary-Side Regulation

Product
Folder
Sample &
Buy
Technical
Documents
Tools &
Software
Support &
Community
Reference
Design
UCC28700, UCC28701, UCC28702, UCC28703
SLUSB41A – JULY 2012 – REVISED DECEMBER 2014
UCC2870x Constant-Voltage, Constant-Current Controller With Primary-Side Regulation
1 Features
•1 < 30-mW No-Load Power for 5-Star Rating
• Primary-Side Regulation (PSR) Eliminates Opto-
Coupler
• ±5% Voltage and Current Regulation
• 130-kHz Maximum Switching Frequency Enables
High-Power Density Charger Designs
• Quasi-Resonant Valley-Switching Operation for
Highest Overall Efficiency
• Patent-Pending Frequency-Jitter Scheme to Ease
EMI Compliance
• Wide VDD Range Allows Small Bias Capacitor
• Clamped Gate-Drive Output for MOSFET
• Protection Functions: Overvoltage, Low-Line, and
Overcurrent
• Programmable Cable Compensation (UCC28700
Only)
• NTC Resistor Interface (UCC28701, UCC28702
and UCC28703 Only) With Fixed Cable
Compensation Options
• SOT-23 Package
2 Applications
• USB-Compliant Adapters and Chargers for
Consumer Electronics (Cell Phones, Tablets and
Cameras)
• AC and DC Power Supplies
3 Description
The UCC28700 family of flyback power supply
controllers provides Constant-Voltage (CV) and
Constant-Current (CC) output regulation without the
use of an optical coupler. The devices process
information from the primary power switch and an
auxiliary flyback winding for precise control of output
voltage and current. Low start-up current, dynamically
controlled operating states and a tailored modulation
profile support very low standby power without
sacrificing start-up time or output transient response.
Control algorithms in the UCC28700 family allow
operating efficiencies to meet or exceed applicable
standards. The output drive interfaces to a MOSFET
power switch. Discontinuous Conduction Mode
(DCM) with valley switching reduces switching losses.
Modulation of switching frequency and primary
current peak amplitude (FM and AM) keeps the
conversion efficiency high across the entire load and
line ranges.
The controllers have a maximum switching frequency
of 130 kHz and always maintain control of the peak-
primary current in the transformer. Protection features
help keep primary and secondary component
stresses in check. The UCC28700 allows the level of
cable compensation to be programmed. The
UCC28701, UCC28702, and UCC28703 devices
allow remote temperature sensing using a Negative
Temperature Coefficient (NTC) resistor while
providing fixed cable-compensation levels.
Device Information⁽¹⁾
PART NUMBER PACKAGE
BODY SIZE (NOM)
UCC28700
UCC28701
UCC28702
SOT-23 (6)
2.90 mm × 1.60 mm
UCC28703
(1) For all available packages, see the orderable addendum at
the end of the datasheet.
Typical Application Schematic
VBLK
CB1
CB2
+ VF -
NP
NS
COUT
RPL V_OUT
VAC
VAUX
NA
RSTR
+ VFA -
RS1
CDD
UCC28700
SOT23-6
VDD
DRV
VS
RLC
CS
RS2
CBC
RCS
RCBC
GND
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.