TPS79718-Q1 Datasheet, PDF (1/13 Pages) Texas Instruments – ULTRALOW-POWER SC70/SOT-223 PACKAGED 10MA LDO LINEAR REGULATORS WITH POWER GOOD OUPUT

Actual Size
(2,15 mm x 2,3 mm)
TPS79718ĆQ1
TPS79730ĆQ1
TPS79733ĆQ1
SGLS264 − SEPTEMBER 2004
ULTRALOWĆPOWER SC70/SOTĆ323 PACKAGED 10 mA LDO
LINEAR REGULATORS WITH POWER GOOD OUTPUT
FEATURES
D Qualification in Accordance With AEC-Q100^†
D Qualified for Automotive Applications
D Customer-Specific Configuration Control Can
Be Supported Along With Major-Change
Approval
D 10-mA Low-Dropout Regulator
D Ultralow 1.2-µA Quiescent Current at 10 mA
D 5-Pin SC70/SOT-323 (DCK) Package
D Integrated Power Good Output
D Stable With Any Capacitor (>0.47 µF)
D Dropout Voltage Typically 105 mV at 10 mA
(TPS79733)
D Over Current Limitation
D −40°C to 125°C Operating Junction
Temperature Range
† _{Contact Texas Instruments for details. Q100 qualification data}
available on request.
APPLICATIONS
D Battery Powered Microcontrollers and
Microprocessors
DESCRIPTION
The TPS797xx family of low-dropout (LDO) voltage
regulators offers the benefits of low-dropout voltage and
ultralow-power operation. The device is stable with any
capacitor (>0.47 µF). Therefore, implementations of
this device require little board space due to the
miniaturized packaging and potentially small output
capacitor. In addition, the family includes an integrated
open drain active-high power good (PG) output.
Intended for use in microcontroller based,
battery-powered applications, the TPS797xx family’s
low dropout and ultralow-powered operation results in
a significant increase in system battery operating life.
The small packaging minimizes consumption of board
space.
The device is enabled when the applied voltage
exceeds the minimum input voltage. The usual PNP
pass transistor has been replaced by a PMOS pass
element. Because the PMOS pass element behaves as
a low-value resistor, the dropout voltage is low, typically
105 mV at 10 mA of load current and is directly
proportional to the load current. The quiescent current
is ultralow (1.2 µA typically) and is stable over the entire
range of output load current (0 mA to 10 mA). When
properly configured with a pullup resistor, the PG output
can be used to implement a power-on reset or low
battery indicator. The TPS797xx is offered in 1.8-V, 3-V,
and 3.3-V fixed options.
DCK PACKAGE
(TOP VIEW)
PG
1
5
OUT
GND
2
NC
3
4
IN
TPS79733
GROUND CURRENT
vs
FREE-AIR TEMPERATURE
2
VI = 4.3 V
1.75
VO = 3.3 V
Co = 1 µF
IO = 10 mA
1.50
1.25
1
0.75
0.50
−40 −15
10
35
60
85
TA − Free-Air Temperature − °C
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
www.ti.com
Copyright  2004, Texas Instruments Incorporated
1