TPS54612QPWPRQ1 Datasheet, PDF (1/21 Pages) Texas Instruments – 3-V TO 6-V INPUT,6-A OUTPUT SYNCHRONOUS BUCK PWM

www.ti.com
Typical Size
6,6 mm X 9,8 mm
TPS54611ĆQ1, TPS54612ĆQ1
TPS54613ĆQ1, TPS54614ĆQ1
TPS54615ĆQ1, TPS54616ĆQ1
SGLS266G − OCTOBER 2004 − REVISED JUNE 2008
3ĆV TO 6ĆV INPUT, 6ĆA OUTPUT SYNCHRONOUS BUCK PWM
SWITCHER WITH INTEGRATED FETs (SWIFT)
FEATURES
D Qualified for Automotive Applications
D 30-mΩ, 12-A Peak MOSFET Switches for High
Efficiency at 6-A Continuous Output Source
and Sink
D 0.9-V, 1.2-V, 1.5-V, 1.8-V, 2.5-V, and 3.3-V Fixed
Output Voltage Devices With 1% Initial
Accuracy
D Internally Compensated for Easy Use and
Minimal Component Count
D Fast Transient Response
D Wide PWM Frequency − Fixed 350 kHz,
550 kHz or Adjustable 280 kHz to 700 kHz
D Load Protected by Peak Current Limit and
Thermal Shutdown
D Integrated Solution Reduces Board Area and
Total Cost
APPLICATIONS
D Low-Voltage, High-Density Systems With
Power Distributed at 5 V or 3.3 V
D Point of Load Regulation for High
Performance DSPs, FPGAs, ASICs and
Microprocessors
D Broadband, Networking and Optical
Communications Infrastructure
D Portable Computing/Notebook PCs
DESCRIPTION
The SWIFT family of dc/dc regulators, the TPS54611,
TPS54612, TPS54613, TPS54614, TPS54615, and
TPS54616 low-input voltage high-output current
synchronous-buck PWM converters integrate all required
active components. Included on the substrate are true,
high-performance, voltage error amplifiers that provide
high performance under transient conditions; an
under-voltage-lockout circuit to prevent start-up until the
input voltage reaches 3 V; an internally and externally set
slow-start circuit to limit in-rush currents; and a power good
output useful for processor/logic reset, fault signaling, and
supply sequencing.
The TPS54611−6 devices are available in a thermally
enhanced 28-pin TSSOP (PWP) PowerPAD package,
which eliminates bulky heatsinks. Texas Instruments
provides evaluation modules and the SWIFT designer
software tool to aid in quickly achieving high-performance
power supply designs to meet aggressive equipment
development cycles.
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam during
storage or handling to prevent electrostatic damage to the MOS gates.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments
semiconductor products and disclaimers thereto appears at the end of this data sheet.
PowerPAD and SWIFT are trademarks of Texas Instruments.
PRODUCTION DATA information is current as of publication date. Products
conform to specifications per the terms of Texas Instruments standard warranty.
Production processing does not necessarily include testing of all parameters.
Copyright  2008 Texas Instruments Incorporated