TPS5120_15 Datasheet, PDF (1/24 Pages) Texas Instruments – DUAL OUTPUT,TWO-PHASE SYNCHRONOUS BUCK DC/DC CONTROLLER

TPS5120
DUAL OUTPUT, TWOĆPHASE SYNCHRONOUS BUCK DC/DC CONTROLLER
D Independent Dual-Outputs Operate 180°
Out of Phase
D Wide Input Voltage Range: 4.5-V – 28-V
D Adjustable Output Voltage Down to 0.9 V
D Pin-Selectable PWM/SKIP Mode for High
Efficiency Under Light Loads
D Synchronous Buck Operation Allows up to
95% Efficiency
D Separate Standby Control and Overcurrent
Protection for Each Channel
D Programmable Short-Circuit Protection
D Low Supply (1 mA) and Shutdown (1 nA)
Current
D Power Good Output
D High-Speed Error Amplifiers
D Sequencing Easily Achieved by Selecting
Softstart Capacitor Values.
D 5-V Linear Regulator Power Internal IC
Circuitry
D 30-Pin TSSOP Packaging
INV1
FB1
SOFTSTART1
PWM/SKIP
CT
5V_STBY
GND
REF
STBY1
STBY2
FLT
POWERGOOD
SOFTSTART2
FB2
INV2
SLVS278E – AUGUST 2000 – REVISED MARCH 2003
DBT PACKAGE
(TOP VIEW)
1
30
LH1
2
29
OUT1_u
3
28
LL1
4
27
OUT1_d
5
26
OUTGND1
6
25
TRIP1
7
24
V_CC
8
23
TRIP2
9
22
VREF5
10
21
REG5V_IN
11
20
OUTGND2
12
19
OUT2_d
13
18
LL2
14
17
OUT2_u
15
16
LH2
description
The TPS5120 is a dual channel, high-efficiency synchronous buck controller where the outputs run 180 degrees
out of phase, which lowers the input current ripple, thereby reducing the input capacitance cost. The PWM/SKIP
pin allows the operating mode to switch from PWM mode to skip mode under light load conditions. The skip
mode enables a lower operating frequency and shortens the pulse width to the low-side MOSFET, increasing
the efficiency under light load conditions. These two modes, along with synchronous-rectifier drivers, dead time,
and very low quiescent current, allow power to be conserved and the battery life to be extended under all load
conditions. The 1.5 A (typical) high-side and low-side MOSFET drivers on-chip are designed to drive less
expensive N-channel MOSFETs. The resistorless current protection and fixed high-side driver voltage simplify
the power supply design and reduce the external parts count. Each channel is independent, offering a separate
controller, overcurrent protection, and standby control. Sequencing is flexible and can be tailored by choosing
different softstart capacitor values. Other features, such as undervoltage lockout, power good, overvoltage,
undervoltage, and programmable short-circuit protection promote system reliability.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
Copyright  2002, Texas Instruments Incorporated
1