English
Language : 

TNETEL1400 Datasheet, PDF (1/15 Pages) Texas Instruments – EtherLoopE TRANSCEIVER
TNETEL1400
EtherLoop™ TRANSCEIVER
D Single-Chip EtherLoop Transceiver
D Programmable Transmit (TX) and Receive
(RX) Gain Via Digital Interface
D Low Overall Power Consumption
D Power-Down Mode Minimizes Server
Modem Power Consumption in Multiplexed
Applications
D Low Noise
D Low Distortion
SPHS004A – FEBRUARY 1999 – REVISED MARCH 1999
D All Terminals Protected to Survive, Without
Damage, a Simulated Static Discharge of
1 kV From a 100-pF Capacitor Applied
Through a 1.5-kΩ Resistor With Respect to
Chip Ground (VEE)
D Single-Rail 5-V Power Supply
D Operating Temperature –40°C to 85°C
Ambient
– Allows Operation in Central Office and
Distributed-Server Modem Applications
D 48-Pin Thin Plastic Quad Flatpack
PT PACKAGE
(TOP VIEW)
VEE 37
NU 38
RXIP 39
RXIN 40
NU 41
VEE 42
VCC 43
REMN 44
TXOP 45
TXON 46
REMP 47
VEE 48
24 VEE
23 TXGAIN3
22 TXGAIN2
21 TXGAIN1
20 TXGAIN0
19 ANG
18 REFP
17 RXBIAS
16 TXBIAS
15 VCC
14 VEE
13 VEE
description
NU – Not used
The TNETEL1400 is an Etherloop transceiver. EtherLoop technology enables simultaneous voice and Ethernet
communication over local-loop plain old telephone service (POTS) wiring. The TNETEL1400 supports data
rates of up to 6 Mbit/s and POTS wire lengths of up to 21,000 feet. Figure 1 shows a typical system with an
EtherLoop modem located at each end of the POTS line. Each EtherLoop modem has a 10Base-T Ethernet
interface and is responsible for buffering Ethernet data before sending it over the POTS wire. The server-end
(SE) EtherLoop modem is located in a central switching office and can communicate with several client-end
(CE) EtherLoop modems, based on a round-robin arbitration scheme. The CE EtherLoop modem typically is
located at a remote site.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
EtherLoop is a trademark of Elastic Networks.
PRODUCT PREVIEW information concerns products in the formative or
design phase of development. Characteristic data and other
specifications are design goals. Texas Instruments reserves the right to
change or discontinue these products without notice.
Copyright © 1999, Texas Instruments Incorporated
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
1